Here we are in week six of flower and not a lot has happen this week other than the usual watering and letting her do her thing. Only trouble this week was updating GoPro had to try a few times. Other than that we got some rain in my home town and collected about 60 gallons that I'm going to use to finish the rest of the grow. Also, got my new AC Infinity CLOUDLINE T4, Quiet Inline Duct Fan System with Temperature and Humidity Controller, 4-Inch. I was really hoping this two plants would finish before the year ended, however, it looks like they got others plans. See you guys next week.

I lost almost all my photos on my phone due to my storage being full so I don't have any of my harvest photos but I will try growing this strain again outdoor next year but I'll make sure to start my IPM before I have big issues next season 😅 I would recommend anybody to try growing some gps gg4 s1 the plant was started in late February and wasn't harvested until almost Halloween (Oct 24th) so all in all she did well,zero seeds and I stressed this plant to the max during early veg,late veg and early flowering so definitely has amazing stress resistance

Hello. This is the end of week 6 and the beginning of week 7 of flowering. It's been hot here this week. Over 30* c for the last 5 days in the green house. I was busy with my Panty Punch harvest and didn't check them through the day. When I closed up for the night 2 days ago, I found them all wilted from lack of water. But they all have more yellow leaves because of that. They are also pulling nutrients from the big fanleaves getting near the end of flowering. After pollenating the clones (see the short video) I cut down the Panty Punch male so as not to seed anyone else's cannabis plants, But it's the beginning of July and there shouldn't be any cannabis plants that are flowering outside just yet. I forgot to take pictures of the 3 inside plants this week. I think one might have gone hermy on me. I'm seeing a lot of brown pistils on the plants that should be white. I took a quick look but didn't see any male flowers. Will have to look closer later. No sign of problems. Still a month to go before harvest. Things are going good. Ok. Have fun out there. Chuck.

Another mostly positive week completed. Pests firmly at bay. Environment humidity looking good and all the buds are getting bigger. Top dressed some nutrients / insect frass earlier in the week which I’m sure was a week or so late. - Heidi looking very hungry by D57 - the whole plant is looking yellow. Solution to problem is some organic liquid nutes which arrived today from now as needed. Overall they and the other 2 ladies in the tent are looking a zillion times better than my first grow. Starting to feel the harvest impatience kick in. Will try to overcome this time Thanks for reading have a great week 😊

I did final transport into 2 gl fabric pots with happy frog soil. I've increased the watering to 2 cups every 48-72 hours with a nice spray to get the leaves and the top soil. I also bought this grey container that you add water to and it feeds your plants CO2 for 2 weeks. There are some plants that are 9 in but majority is about 6 3/4-7 1/4 in tall. They seem like they will be bushy. And lastly some of the leaves on 2 or 3 plants are curling inward so I'm curious to understand what's going on. I haven't gotten nutrients cause the soil has enough for 30 days and by that time it will be 4 weeks left in grow and switching to flower so I may use some the 1st 2-3 weeks after veg and flush the last 1-2 weeks.

She has performed very good with the lst method, nice plant, fast growth, quality flowers, it's a very good choice for everyone who's looking for a good quality strain at affordable prices. Very nice genetic, this phenotype concretely has a very sweet and floral terps. You can check the other 2 phenos of ak420 here at my page

Day 66 harvest. Let’s see if terps stay.

20den 🍀 Roste to krásně ,i když už potřebovala zalít ,zalivam půl lítrem každý druhy den ,ať má holka čas :) a v neděli začínám hnojit růstovým hnojivem . Hnojiva co používám jsou Micro,Velk,Mag a Grow . 1,5ml/l Tento víkend mám v plánu jí zastřihnout ,zastrihavam pouze jednou. . Konečně pak začne lehké cvičení :) . Už mě nebaví se jen koukat 😀

Hey Leute die strains machen sich sehr gut man kann gut unterschied Sativa indika /indika sativa sehen das unterschiedliche strain hybride sie wachsen sehr gut die machen keine Probleme bis jetz unkompliziert

Erde ist eine sehr luftige aus einem Garten Fachgeschäft, welche sehr leicht vorgedüngt ist, mit einem NPK Dünger. Möchte versuchen alles aus dieser Sorte heraus zu holen. Beigesetzt habe ich 1 Sack mit 10 Litern Plagron Perlit, welches vor der Zugabe gründlich abgewaschen wurde. Eine ganze Packung Royal Queen Seeds Easy Boost habe ich von Anfang an der Erde beigemischt. Dann wurde der gesamte Airpot mit seinen 38 Litern Volumen, einmal mit Wasser gefüllt, damit der Organische Dünger aufquellt. Dieser wurde dann mehrmals von mir durchgemengt, damit die aufgequellten Organischen Düngerteile sich möglichst gleichmäßig in der Erde verteilen. Nachdem die Erde nach über 1 Woche durchgetrocknet war, wurde diese erneut aufgelockert. Dann kam der Samen Zamnesia Banana hinein, welchen ich 4 Tage vorgezogen habe. Der Samen ist sehr, sehr Gut, da er von vorne herein eine sehr starke, praktisch absolut gerade Wurzel nach Unten gebildet hat. Das weiß ich, da ich den Samen in einem gereinigten, durchsichtigen Plastikbehälter vorgezogen habe, in dem vorher geiles Minzeis aus dem Aldi drin war. Start war der 07.11.2020. Habe Gestern das erste mal einen Hauch von dem Plagron Flüssigdünger auf 1 Liter Wasser gemischt, ca. 0,5 ml. Die kleine mochte die Dosis sehr. Mit PH Down habe ich den Wert von der Mischung auf den PH Wert 6.6 eingestellt. Lampe ist ein SMD Chip mit 65W, genauer der Cree CXB 3590. 1 Der Photonenstrom liegt bei 137,5 µmol/s, was ich für einen Einzelnen Chip in dieser Größe für sehr ordentlich halte. Auf den Wert komme ich, aufgrund der Angabe einer 4 er Lampe, die 4 solcher Chips enthielt. Diesen Wert habe ich dann durch 4 geteilt. Das habe ich wiederum getan, weil ich keine Angaben mit einem Strahlungsdruck Messwert zu diesem Chip im Internet fand, nicht einmal in dem Herstellerdatenblatt. https://proemit-576b.kxcdn.com/shop/media/pdf/b9/c8/eb/ds-CXB3590-1.pdf https://www.ledrack-growled.com/wp-content/uploads/2018/08/Produktdatenblatt18-LedRackPlusKit-TechLed_Swiss.pdf 1 Weiter im Text, dieser ist erfahrungsgemäß stark genug, für 1 Pflanze auf 500mm x 500mm. Growbox ist ein Eigenbau aus OSB Platten mit 12 mm Stärke, welche 4 140 mm Lüfter mit Vorwiderstand, welche durch ein Universales 12V Netzteil versorgt werden, verwendet. Reflektoren sind eine Rettungsdecke und Alufolie. Ich bin gespannt wie der Grow wird, denke ich werde mehrere Triebe durch Topping und später durch Entlaubung.

The stretch is slowing down and the buds are starting. The one I topped has lots of bud sites 👍 we will see witch has a better yield. It has a fruity smell with a diesel after smell. 🔥🔥

This run i'm gonna play around a bit with Bio-tabs & Biobizz for the In House genetics and Aficionado French connection strains i got. For LIT Farms Diamond Gelato & Dutch Passion The Ultimate i'm gonna stick with what i know best ( Canna Terra & Advanced nutrients combo ). All plants have been transplanted to their final home's on 06-15 in 5 gal's and all of them are doing fine, even with the extreme heat and drought we got over here at the moment, to be continued. Stay elevated growmies💚

Week 6 for the Kongs krush from greenhouse seeds This week we placed a net above the plants to avoid any branches to hang around because of the weight. We continued this week with sugar shot and Sticky fingers from Xpert nutrients The buds are getting more and more thc and we are coming to the end of flowering soon

Everything seems to be going great. The buds are developing nicely and there are no signs that plants are stressed at all. I hope they continue to fatten up over the next few weeks for a good harvest!

High, The clones have rooted and will now become mother plants. First pistils appeared on FD12. Have a good time. Stay green.🌱👨‍🌾🏻💚

Day 41: nutrients like plan --------------------------------------------- Added some non organic nuts. to boost the flower. Can someone give me advise for an organic pk booster? She is getting frosty ❄️🦍 Happy growing 🌱

Seedlings stretched a bit had to put them under the light early. Popped 2 seeds initially with 2 freebies I got, unfortunately the freebies didn't germinate in a week so I tossed them and popped two more Dolatos and all four germinated with 100% success rate. Kept them on a 20/4 schedule watering them only once and sprayed the top soil with a mister every now and again. 👍🏿

Nothing special, everything is actually working. Clearly once my water was at the right temperature, no more worries. The flowers arrived at 12/12 + 11 with the trichromes that pop, it starts to be pleasant! So of course, I'm not going to break any records on this RUN but in any case, I've eliminated a lot of "novelty" and mistakes that I'll make more. I'm counting on the run I'm re-launching to blow all that up, I'm going to go for a performance goal The stretch is off to a good start, it should settle down around 12/12 +21 - 28, so I will place my second net next week. I have done a defoliation. I change the soup in 2 days, so my solution lasts 10 days. I have a slight over-fattening, but really nothing serious, I will switch to an EC of 1.8 - 1.9 instead of 2.0. and I will observe. Here we can see the delay of one of the plants, it's as if I was shooting with only 3 plants. Next time, only one strain, same size of cuttings and passage by cuttings and RDWV DIY mandatory before passage in the V-system. Next week, I change the brand of fertilizer for the RDWC, I go to Athena, I will introduce the PK of Athena which according to their recommendation starts at the 21st day at a rate of 2ML/L. I turn with the base sensi bloom a and b + athena pk Otherwise, I receive the parts this week for my RDWC DIY system for growth, I'll make it with my friend and I'll test it and I'll give you a feedback on the next update, especially since I'm going to restart right away, I'm going to do 10-15 days in cuttings and then I'll go to the RDWC DIY system for growth until I finish the FLO of the V-SYTEM and then I'll go straight to the next one. I'm going to put my LEDS at 80% which is the MAX recommendation of SANlight without c0² ( I don't forbid myself to grow at 100% in week 5-6, I'll see... )