At some point stopped conducting this diary. It was not for this mood. But the last week, I decided to bring the case to the end. So, the plant very quickly bloomed and matured. In fact, already now, on the 63rd day I can make harvesting. The smell during flowering is very weak and pleasant. Plant height is about 30 cm (12in). I remind you pot has a volume of only 1 liter (0.3 gallon). There were no special problems - I just burned the tips of the leaves with overdose of fertilizers. I think that for such small plants should not exceed the dosage of 500-600 PPM. It is better to feed each watering in small doses. Later I will write which fertilizers I used. After one or two days I plan harvest.

13-02 seeds in wet papertowel and in ziplockbag 15-02 4 out 4 germ. placed in 1 inch hole in prewatered soil 17-02 4 seedlings, looking good 19-02 a little stretchy, measured ppfd and adjusted lamp to 30 cm above plant and dimmer set to 50% from 25% 20-02 water, 100ml pr plant 21-02 nice looking leaves. 22-02 water, 100ml pr plant

i harvested the top part of my grapefruit plant as i checked the trychones and they were 20% amber the lower half had mostly cloudy but no amber ro im going to give it a last feed then flush in about 5 days for 7 days should bd ok then .. Ive raised thr grapefruit off the ground to stop fluids mixing between them as one gonna have a few more feeds where the other is on flush My other plant the bushy banana blaze is foing ok had a good 2-3 weeks i rekkon till i even think about harvest

Day 37 from seed. 2nd day into week 6. -My focus for this week is to keep room temperatures under 75 degrees since I notice that my roots don’t like high nutrients temp. And since I m in DWC single 5 gallons bucket I don’t have the possibility to chill the water. So I have to keep the room temp lower then I wish to. - Day 41- I have to add nutrients and PH down every 12 hours. My PPM’s goes from 450 to 390 and my PH drift from 5.7 to 6.2 in less then 12 hours. Also I notice some rust on older levels (probably Ca/Mg deficiency). After some research (I’m new to this) I decided to up the nutrients to 600 PPM’s. Hopefully is a good decision. I will really appreciate some feedback.

We have more autos from Ganja farmer seeds started today. I sowed them directly into the soil. The hydroponic ebb and flow system I am using this round is new and is called AirCube from growace. If your interested in looking for more info on it here's a link to there website 👇 https://growace.com/?rfsn=7577242.b784c7&utm_ source=refersion&utm_ medium=affiliate&utm_ campaign=7577242.b784c7 This will cut out my automatic watering and help bring more oxygen to the roots while still maintaining a fully organic grow.

In this week i decided to only give them another startbooster which contains some rootstimulator. Some days after feeding with startbooster, i gave them some water. There are still so many kinds of nutrients in the soil. The plants look a little light green, i have been checking my run-off water and it should be fine( still higher EC then i used to have but i have already explained why it is that way). I'm not overwatering so it's not a (N)itrogen problem which can most of the time results into light green leaves. ( when there is no nitrogen in the soil the roots will not or barely take any water(nutrients) I had the same thing with other sativas in the past, behind the window before and in later stages it got solved. I still have to remind myself that it is a fun-outside-grow so i should'nt complain about low humidity(40-45) which should be 85%, temperature 20-21 degrees which should be 26-27, being behind a glas window instead of better exposure to the sunlight or lamps, not having fans on it to get better firm stems or closer lightsource so they don't stretch that much. For now i start getting them used to the sunlight by carefully putting them in shade places or with a few hours sunlight. It went well but except for the bigger pot plant, you can see on the highest leaf that it got a little bit curly but still not a big issue. I might buy some Canna Cure this week. Canna cure is good against insects, molts and such. It also holds some nutrients. Very usefull for outside growing. Since i don't want to overwater or overfeed my plants because i want them to root alot, this might be a solution to give them some extra nutrients, it also makes the leaves more green. When the plants are getting bigger and more thick i want to start doing LTS, i order to do so i just have a little bit time left to bully them a bit with keeping them dry for rooting. I don't want to do that while doing LTS. Don't mind the temperature meter, its not 32 degrees outside. It was still inside behind the window between the curtains. It hotter there. ( might also be the reason for some stretch in the plants)

Ascofol (root stimulant) strongly stimulates plant growth using natural hormones, resulting in both plants showing a slight nitrogen deficiency. Day 1 Bloom ( # 1 ) The plants were trimmed before the light was set to a 12/12 cycle. Day 2 Bloom ( # 2 ) Ascofol has a significant effect on the leaf formation of both plants. Day 3 Bloom ( # 3 ) Ascofol has been reduced. The leaves are growing too quickly. ( # 4 ) The plants were trimmed again and inner leaves were removed. ( # 5 ) 6h later, the leaves have repositioned themselves. Day 4 Bloom ( # 6 ) I moved the plants to the bigger tent and light and added my Chili (capsicum annuum) as a neighbor Day 5 Bloom ( # 7 ) I placed the plants on pedestals so that I could put the fans between the pots. ( # 8 ) Short Clip Day 6 Bloom ( # 9 ) The stretch is noticeable, and the plants are also much thirstier. I will now water them twice a day, giving them 2500 ml each time. ( # 10 ) I placed another SCrOG net over the plants and wove in the first branches. The fun begins.

Well here we are a new week for Billie. Come join he on her adventure. Friday Sep 17 Day 50 -No water still -Growth on Billie is just unreal -Added a few more LST staples -I wanna veg her out a few more weeks -May have to send her flower earlier than expected -We’ll see -Grow my girl Day 51 -Feeding 2 gallons with aerated tap water base 62.5 PPM -Add calmag up to 327 PPM -Add Grow up to 968 PPM -2 gallon 6.2 PH - 968 PPM -Runoff 700 ml 5.48 PH - 3300 PPM -Defoliated a little bit -Not much more to say Day 52 -No water -Responded well to yesterday’s feeding -Perked right back up after some light defoliation -just killing it today -She’s a handful to water FML Day 53 -No water -Again growth is crazy -Might have to re evaluate my plans with her and send her to flower sooner than I want to -We’ll see Day 54 -No water -Still just killing it with growth -I can’t keep her waiting three more weeks for Penelope to be ready -Going to have to give up on my original training plan for her -Going to be too hard to water Day 55 -No water -She’s looking happy growth is great -she’s going to need a hair cut soon Day 56 -No water -Still exploding with growth -I might have to send to flower early -We’ll see -Not much more to say for today This is the end of the week. Join us next week to see what the future brings us!

i started with LST. unfortunately the plant grew too fast in height, which doesn't make it any easier now. next week i'll try it with twine. maybe i should it just let it grow as it likes.

Topped all 4 plants once they developed 4 nodes, will be training branches out this time to open up the middles of plants

Topped her again! I came back to this beauty after almost 10 days of feeling like trash. She was getting the minimum amount of attention, but has stayed strong. I have a couple of Autoflowers to finish up, then I will be transplanting her once she has recovered from the topping to a 7 gallon fabric pot. I will probably try to run a SCROG and see if I can fill my 2x4 tent with the one plant.?🤔 Conditions have been good, 76 degrees and 60% RH. Temps at night are still pretty cool so I kept the small heater going for now. I will start bringing the EC up a bit over the next couple of weeks to see if I can get her to really feed, she has shown no signs of nutrient burn yet 🤞Happy Gardening 🇨🇦👊❤️💨

Week 3 of my soon-to-be purple ladies! 😻 Everything was going well but I noticed these issues: - The girl on the back is stretching waaaaay more and is less "leafy" than her sister. Perhaps she has more sativa in her DNA? - Leaves on both girls love to twirl around, specially on the girl on the front. - The stem on both girls is still weak and the girl on the front no longer needs the extra help she needed! Weather where I live is getting colder for some odd reason (it should be the opposite, damn!) and the "purple" is... perhaps starting to show a little? Which is good!? 😮 Anyway, that's all for this week. See you all next one and I hope you'll all enjoy the photos and the timelapse! 😁

The weather's finally starting to warm up. It feels so good to have the sun out and to open the windows. With all this extra sunshine, my pound cake plant is really taking off! It's growing so fast, and it's starting to look really full and healthy. I can almost see tiny buds on the ends of the branches - maybe it'll even have flowers soon!

After keeping an eye on the tricomes I've seen most of them turn white so last night I mixed 1.5ml/L of flawless finish and saturated the soil and left to set overnight this morning I flushed all 3 plants so far they dont look stressed out at all I was scared being my first time yet I still dont know if it was successful

—SETUP— .BOSSLED LED 1800W full spectrum, real power consumption is +-250W. .Grow space 60X100X200(a simple shower box. .AN nutes and other simple additives. .Grow medium is 60% peat, 30% perlite, 10% organic correction(worm castings), 5 gallon fabric pots(18l). —BRIEF— Hi there, I have tried already done this genetic outdoors, in poor lighting and a general purpose nute from Neudorff, yielded 25g dry, in 3gallon pots same medium. So this is a good experiment, lets see indoors how she will compare. —GERMINATION— My germination process always start by scarifying the seeds, i created a little tool for that. I just a little container with sandpaper walls. Shake gently for about 60 secs+, this allows for the water to penetrate better in the seed shell, once you soak. Then i soak overnight from 12 to 20 hours max. From there i either plant straight or use the paper towel method to see the tap root before. If you are a bit on the impatient side seen the tap root is advisable so you see some movement before planting. Lol! —ROYAL QUEEN SEEDS . QUICK ONE . INFO — Chose this strain because is basic and I have to travel for a month soon, and someone else is going to take care for this time. :) Quick One is a fast-growing autoflowering strain. This was one of the first autoflowering strains developed. When it was first released, it was one of the quickest growing strains on the planet. THC: 13% CBD: Low Yield Indoor : 275 - 325 gr/m2 Yield Outdoor: 100 - 150 gr/plant Height Indoor: 50 - 60 cm Height Outdoor: 60 - 100 cm Flowering: 5 - 6 Weeks Harvest month: 8-9 weeks after sprouting Genetic Background: Strong Indica x Ruderalis Type: Sa 10% In 60% Ru 30% Effect: Physical Climate: Mild —RQS QUICK ONE GERMINATION UPDATE— My mood said to me to plant straight, so scarify > soak 18 hours +- > plant straight. Seedlings look a bit odd, with a yellow center, let's give her some days in and see what happens next.