Amazing!! Ya buddie!

been doing some topping as the plant grows trying to spread the canopy along with trimming off the large fan leaves near the bottom not get much light. power flower is about 5 inch tall I've been letting the plants grow to the lights and haven't been seeing any issues so far. Power Flower has the 1000W @ 15" away from the top Holy Punch has the 600W @ 6" away from the top

Good week

The plants are growing steadily. I’ve already had to adjust the lamp height several times because the largest plants are starting to get dry leaf tips. I need to try to lower the humidity, as it gets very high when the tent is closed, and even though many of the side openings are open, the humidity is still extremely high.

Room setup rundown, examples of bud, et al in pictures... Seedlings/Clones lights - Viparspectra XS1500. Vege lights - Mars Hydro FC-4800 Flower Lights - 650w 3400K 1900umol/s PAR, (3) 226w DIY 2900K 630umol/s PAR (678w and 1890umol/s), Substrate - 50/50 sphagnum peat moss and vermiculite in 5-gallon pots Climate Control - Luckily, the lights, winter and normal furnace use all equate to a decent temperature, though a bit on colder side in in vege phase, sadly. Humidifier is needed early and later a dehumidifier is needed when canopy develops. I only grow in the winter months. Irrigation - do not use the emitters in this diary. They suck a big fat dick to skip a line to suck a bigger dick. Use the pressure compensating type. https://growdiaries.com/diaries/232811-strawberry-cookies-og-r1-cherry-diesel-bbgs-ego-epg-ebg-grow-journal-by-001100010010011110/week/1366923 -- use something similar to those. They come in different shapes, too. Basic process The little light takes care of seedlings in 2.5" wide seedling pots until first up-pot. The 1-gallon pots fit well under the FC4800 in a 4x4 tent until day 21 after sprout. I plant 150% or more of what i need, so i can kill the weak without concern. The goal is for every plant that makes it to the 5-gallon up-pot being capable of producing a minimum of 160 grams with a maximum of a 35-40 day vegetative phase. Third up-pot is into 5-gallon nursery pots and now under the 3 DIY lights and the 650W light in the big tent for a couple more weeks of vege. An irrigation system in the big tent saves a lot of time. One scrog for training and another for support, just in case. Reverting back to a more systematic approach to canopy composition moving forward. About 2.3 colas per sq ft and 8 primary colas per plant. Yields were similar when over-crowding and being less systematic, but the proportion of less dense nugs is greater and trim time is needlessly elevated because of that fact. I was very controlling about this the first couple years but got away from it for far too long at this point. Drying / Curing - Into mesh racks for 9 days. I wet trim and cut down to similarly sized buds for even drying. Temps are controlled around 68F and RH is set to 60%. Then into some 5-gallon buckets with gamma seal lids and (3) 2-way 67g boveda humidipaks (58% or 62%) in each bucket - 1 at bottom, 2 at top. Temp/RH probe confirms that they hold the RH steady at 60-63%. Cost - 0.33 cents (USD) per gram produced. This includes an accelerated depreciation expense for all equipment used, fertilizer, water, electricity for all equipment used, new filters and other yearly purchases - bti, ph strips, sticky traps, etc. I'm a finance guy, so these numbers are comprehensively accurate and purposely err slightly on high side of cost. The only facet not included is the cost of my labor.

It's her first week on 12/12. Changed to 6-12-36 powdered nutrients now.

Welcome! In this grow we have: 2x Platinum Wedding Crasher 2x Gelato 41 1x Sour OG 2x Lemon Kush Germination/Rooting - 14 Days 9/17/21 - The clones look good in solo cups of soil. We will transplant into 5 gallon pots in the grow tent after they fully root in the cups. 9/18/21 - Looks like the clones are doing well in soil! We are so excited to grow these out. The clones came from a very highly respected grower. 9/19/21 - No ugly growth. All clones look amazing! We upgraded the light to a Mars TSW 2000. 9/20/21 - They are looking good and most likely rooting throughout the cups. I’ll give them a little bit of water today. I want the roots to go looking for the water so I’ve kept them slightly dry. 9/21/21 - They look happy. I will let them just do their thing… We are waiting on our Mars TSW 2000 light to show up anyways. No roots visible from the drainage holes in the cups. 9/22/21 - Looking really healthy and growing nicely. I’m excited for them to fully root in the cups so we can transplant them into the tent. The Mars TSW 2000 should be here in the next few days. 9/23/21 - Looking so good! We can’t wait to get these under the Mars TSW 2000 in the tent. They smell and look great. 9/24/21 - The clones look really good except for one Sour OG. It wilted and died, roots did not take unfortunately. I have a Lemon Kush started from seed we will grow in place of the dead Sour OG. Today we got our Mars Hydro TSW 2000 light. We will be hanging it and updating with pics/videos. 9/25/21 - They look amazing. Lots of growth while rooting. 9/26/21 - So far so good. Watering when the cups get light in weight. In just a few days we will be transplanting. See the video for today, we hung the Mars Hydro TSW 2000! 9/27/21 - Watered them yesterday, they look healthy. The Lemon Kush isn’t a clone, it is from seed. It’s the smallest girl but it’ll perk up quickly. 9/28/21 - Transplant day!! The clones are looking really good and it’s time to transplant into the 4x4 under that Mars Hydro TSW 2000 at 50% intensity. Check out the pictures and videos from today!

Umgezogen, sollte etwas zeitverlängerung einbringen 🐝

Ripening started way faster than anticipated and I started flushing the other Critical at day 46 and she looks like she might be ready at the end of the week.. BUT I'm going to send her all the way to couchlock heaven so I'll probably chop her at the same as the other one which I reckon will be receiving at least one more full-dose nutrient blast and around two weeks of flush but lets see.. I want her to be close to fully finished but not too many ambers since the other one will be majorly overcooked. Didn't put too much effort on this timelapse since my PC is hiccuping pretty darn hard trying to process the camera RAW files to video if I put some effects on them.. wonder why since I got a pretty solid rig with 5950X and 128GB of DDR4-3866 RAM.. damn shitbucket can't handle somewhere around 1.5-2GBps bitrate video realtime😂

Good little week, showing some signs of a PH swing in the medium will have to adjust the amount of PH down I add into the mix. I have not been monitoring the PH as it always seems to do just fine. But when I did it this time it was hitting 4.0-4.2 so its a big swing. To bad I only did this after the fact with the left overs. Next week will get no PH down. Flipped it to flower at the beginning of the week, doing 12/12 on 40% as I might be away for a bit and if my friend needs to take care of the plants I don't want them working about to much DLI. So its getting under fed in light a bit but that's ok. When I am back I can increase it or just leave it as is. Added in its first dose of Acadie See Weed extract 15ml/gal 0.6-0-6, its recommended dose is 5ml/L so 15ml/1gal is good, also added some more of the Fish Hydrolysate 2-4-0.5 about 7ml/gal, its recommended dose is 30ml/gal every 2-4 weeks so this works out well if I am feeding them weekly. The one THCv plant by GTR is not doing so hot, it has not grown at all and barley drank anything since last week so I am just leaving it alone and hopes it will bounce back. Everything else is getting nice and bushy. All the herbs are doing well, cat nip is growing in nice and bushy with the pinching, same with the basil. The dill and cilantro is getting leggy and likely going to chop them and use them in some cooking. got a fish dish that would be nice, turn em into tacos. Other then that I think that's it. O yea. The nutrients are all fucked up. It shows me some ml/l options but all the labels are gone so no idea whats happening, any questions just ask.

Coming along nicely. Should be a good little bud stick by the end.

Buenas a tod@s... Otra semanita más ya en flora, van creciendo muy bien, uniformes, hermosas y fuertes... Ricos aromas ya están formándose los cogollos de a poquito, van tomando forma de a poco, me encantan, se las ve muy bien y aguantan muy bien la temperatura ya q hay veces q hace bastante calor, se toman otras medidas en ese caso pero de momento van muy bien... A seguir creciendo, me está gustando la evolución de este cultivo, y el siguiente, mejor... 💪🏻⚡💀😎 🇦🇷🤝🏻🇪🇦

Pablo Escobar is still making progress. She had the two neem oil treatments. Hopefully I broke whatever pest is bothering them. Still no sign of what it is. Even under 100x magnification. I might of got it. If not I will get a Insecticide soap of some kind. She is still growing after the treatment stress. I need to resolve it prior flowering is all I know. Until next week..... thank you Spider Farmer, and Divine Seeds. 🤜🏻🤛🏻🌱🌱🌱 Thank you grow diaries community for the 👇likes👇, follows, comments, and subscriptions on my YouTube channel👇. ❄️🌱🍻 Happy Growing 🌱🌱🌱 https://youtube.com/channel/UCAhN7yRzWLpcaRHhMIQ7X4g

Tangerine dream auto from Weed Seed Express grew really well. I had some ph issues in flowering with trying to keep up with her diet. Is a great smelling flower. Should have a strong couch lock effect. I grew it a about a week longer then I should. I am totally OK with that as well. Thank you Viparspectra, and Weed Seed Express. 🌱🤜🤛🌱 There is a harvest video on my YouTube channel as well from a in hand perspective. Thank you grow diaries community for the likes, follows, comments, and subscriptions on my YouTube channel. Happy growing everyone 🌱🌱🌱 https://youtube.com/channel/UCAhN7yRzWLpcaRHhMIQ7X4g

Thanks to growdiaries I followed the entire growing stages of the plant seeing all the little details usually not seen. Sincerly I expected more than 30g with the nutriens and light utilised anyway it is a good result.

May 1st - pH 6.0, PPM 1280, 2.6 EC, 79/70f, 35% humidity - Water change, added purpinator since I found it on sale, plant seems happy from this past week, great sign. :) May 2nd - pH 5.9 -> 6.2, PPM 1380 -> 1260, 2.5 EC, 80/69f, 36% humidity - adjusted pH, likes to read a bit higher than usual according to my pH strips (~.2ish I believe), added a bit of distilled water, PPM was a bit high when testing this morning no idea why though. The plant seems O.K. May 3rd - pH 6.3, PPM 1350, 2.7 EC, 77/68f, 55% humidity - I started to add humidity to the cabinet to keep temps down and to help during flowering, I've got it outside the cabinet plugged into a humidity inkbird set to 60% RH and it'll allow it to fall 12.5% before turning back on. (Not trying run it 24/7) May 4th - pH 6.2, PPM 1350, 2.7 EC, 79/72f, 57% humidity - The plant is chilling, notice maybe some yellow spots on some fan leaves, if this continues I will turn off the humidifier, as that's what happened last time... Also raised the lights again, I wonder how big this one will get. May 5th - pH 6.1 -> 6.3, PPM 1280, 2.6 EC , 77/73f, 50% humidity - upped pH a tiny bit, added water to lower PPM May 6th - pH 6.5 -> 5.9, PPM 1350, 2.7 EC, 75/72f, 42% humidity - adjusted pH and added a little bit of water May 7th - pH 6.1, PPM 1600, 3.2 EC, 78/68f, 44% humidity - bucket is low on water, didn’t want to add a whole thing just to change it tomorrow, will start with more water (3.5gal) and add more water throughout the week compared to this week, I have started to experience clawing, possibly due to nitrogen toxicity, hoping to fix this upcoming week. And a noticed a few tiny rust spots on leaves randomly on the plant (not like it’s just fans or just old or just new growth, it’s sorta spread? Hoping it’s calmag?) Plant looks nice otherwise