Likes
Comments
Share
@Trippin66
Follow
Hi growmies Everything is fine here Sweet zenzation is showing how much XL it is these days I'm going to do some lollipoping and defoliation so as to make her concentrate high Runtz will be defoiled for the last time and then we'll see what she can do Bruce bunner pheno 2 will be watered with only water and for the last time in his life it was wonderful to see his development next week will be cut Pheno 1 bruce banner I have doubts about what to do it seems to me that the flowers grow a little but I don't know whether to follow the pre-established dates or wait since the stress has lengthened the times Thanks for likes and comments Never stop grow✅
Likes
1
Share
@tterpy
Follow
Growing strong 💚 Fed with water 5/17/26
Likes
17
Share
@Kirsten
Follow
This Mystery seed grow #1 is very nearly finished! She will be taken down once I'm satisfied with the ratio of trichomes. I'm leaving this one a bit longer than I usually would, just to see the difference in effects of a later harvest. I do need the space in the tent, so I'm hoping it won't take too much longer. The leaves are losing all of their colour, and this is the first time I've had any "fade". I've had a lot of issues with what I believe is an excess of phosphorus. I had Phosphorus excess in this grow before, and I think that's what's happened again. I believe the Excess of Phosphorus has prevented the plant from being able to uptake Calcium, Magnesium and others. I have learned many lessons again, and plan to avoid these mistakes with my grows presently. 8.5.25: The plant was watered with 2ltrs of dechlorinated water PH'd to 6. This may be the last watering before she's done. I added per litre; ♡ 4ml Ecothrive Trace ♡ 1/2 TSP Sea K(elp) PPM: 715 PH: 6.3. ☆ Xpert Nutrients PH down, up to 1ml. ☆ Ecothrive Neutralise 1 drop per litre from the 1ml pipette, which is attached. This is my dechlorinator. Thanks for following along with this plant 😊💚✌️🍃
Processing
Likes
17
Share
@Fabhz
Follow
flowering process has been slow due to mistakes during vegetation, anyway im trying to help the plant recover. Its flowering week number two, i am very excited.
Processing
Likes
15
Share
@AK1210
Follow
New flowering continues to develop on this lady, she seems to be swelling up day by day. Yellowing of the fan leaves has started which usually means it's time to flush, I need to check the trichomes to see how amber they appear before I do just in case the flavour or yield could be effected.
Likes
31
Share
@Cultivate
Follow
Struggled keeping humidity up I think it’s my filter but I don’t know. Tried most tricks in the book and had to invest in a humidifier ( not the best either). I know it’s frowned upon to use foliage spray sometimes as it can cause mould/light burn but my humidity levels are some what in the middle
Likes
132
Share
Welcome to Bud Boutique Grow Diary - really appreciate all your love and support :) Dont forget to check out my other current grows! 🗓️ THE END: - After 14 Day of drying with around 15-16°C and 60% rh its finally time - LETS TRIM - beautiful cheesey smell while trimming - bud full of Trichs all over (shinning like diamonds) - 2/3 Phenos the MOST BEAUTIFUL of this whole run!!! - looking super duper beautiful !!!! - Curring them in Grove TerpLoc Bags - Watch out for my upcoming smoke review! Thank you for staying with me - This wonderful Journey finally come to an end. The next run is waiting already 💚 ___________________________________________ --- 🌱 Strain --- 🏷️ SWEET CHEESE by Sweet Seeds https://sweetseeds.es/en/photoperiod-dependent-seeds/48-sweet-cheese.html ---💡 Lighting --- 💡LUMATEK ZEUS PRO 600 https://lumatek-lighting.com/zeus-600w-pro-29/ --- 🥗 Nutrients and Feeding * 🍸 PLAGRON Algae Baseline grow/bloom + Additives: Power Roots, Sugar Royal, Pure Enzym, Silic Rock, Power Buds, Green Sensation * 📅💪 baseline grow/bloow: 4ml/l & additives: 1ml/l each https://plagron.com/de/hobby/produkte --- 🏭 Grow Setup --- * 🏠🌿 Indoor: Homebox 120x120x200cm (4x4) * 📐🌀 PrimaKlima exhausting Fan 1180m3/h (running on 60-80%) & Can Light Filter 800m3/h & 1x Fanbox 1x Dyson fan for Air circulation https://primaklima.com/de/shop/ventilatoren-de/ec-ventilatoren/pk160ec-tc/ https://canfilters.com/products/filters/ All Likes and comments are highly appreciated!!! don't forget to check out my Instagram: budboutiquee - Bud Boutique
Likes
77
Share
So far so good. Don’t think I’m gonna do any type of training on these but not 100% yet. Get me ideas on what to do.
Likes
74
Share
@Mr_Maes
Follow
This plant will be grown again for sure. From start to finish there wasn’t a single issue and she performed well under my Optic LED and LST. Can’t wait to grow this again.
Likes
41
Share
15 Day dry then trimmed using the Trim Bin. Curing with Grove bags, first harvest filled 3, 1/4lb grove bags. *Updating with clone pictures of this pheno in late flower labeled in diary as you look through, If I pop a new seed of this strain Ill start another diary
Likes
2
Share
Alles lief gut mit der Shaman bis zum jetzigen Zeitpunkt in der Blüte. Leider beginnt sich an einigen kleinen Stellen etwas Schimmel auszubilden, gar nicht in den Blüten, sondern an den Trieben. Das war mein eigener Fehler, da ich beim Entblättern einige Blätter letzte Woche nicht nach oben ziehend abgezwickt habe, sondern nach unten zur Erde hin gerichtet abgerissen habe. Dadurch habe ich an einigen Stellen das Gewebe am Trieb verletzt, wodurch sich dort Schimmel bilden kann und tut. Ich hoffe es wird sich in Grenzen halten. Es ist jedoch möglich, dass ich durch diesen Fehler zumindest einen der Haupttriebe verlieren kann. Wieder was gelernt. Gibt es irgendwelche Mittel, den Schimmel an den Trieben zu entfernen?Ansonsten bildet sie weiter ihre Buds aus, riecht schon sehr angenehm und entwickelt sich weiter. Es gab ein paar starke Winde und Böen in dieser Woche, dehalb wurde die Shaman vorsichtshalber gegen die Windrichtung angebunden, damit der Topf nicht kippt. Vielen Dank für euren Besuch und passt bei der Entlaubung auf...😫--- Everything was going well with the Shaman until now during flowering. Unfortunately, some mold is starting to form in a few small areas, not on the flowers themselves, but on the shoots. This was my own fault, as I didn't pull some leaves upwards when defoliating last week, but tore them off downwards towards the ground. This damaged the tissue on the shoot in some places, allowing mold to form and grow there. I hope it will be limited. However, it is possible that I may lose at least one of the main shoots as a result of this mistake. Another lesson learned. Is there any way to remove the mold from the shoots? Otherwise, it continues to form buds, smells very pleasant, and continues to develop. There were a few strong winds and gusts this week, so as a precaution, the Shaman was tied against the wind direction to prevent the pot from tipping over. Thank you very much for visiting, and be careful when defoliating...😫
Likes
49
Share
2018-03-20 Day 1 New week and not much to say. No water or nutes today, just the regular weekly check to see that they look nice and healthy. Raised the lamp about 10 cm to make sure that the girls don't get burned again. Zombie Kush nr1 is 58 cm Zombie Kush nr2 is 68 cm 2018-03-22 Day 3 Gave the girls 2l water/nutes this morning. ----------------------------------------------------------------------------------------------------------------------------------------- Strain information From the selection of one of Ripper seeds first genetic search works, an old Lavender Kush clone was pollinated by brilliant Amnesia. From there a clone that we named “Sideral” was selected and decided to pollinate it again later with Bubba Kush. Its vegetative cycle should be generous if we want to develop the full potential of its Indica demeanor. With a low EC both in the vegetative and the flowering cycles we will get spectacular results. Its purplish colour scheme and the great quantity of trichomes that cover its large flowers would make this strain a key one for Kush flavor lovers. Vegetative: From 2 to 4 weeks Genotipe: 20% Sativa / 80% Índica Indoor flowering: 55/60 days. Production: Medium / High Effect: Powerful / Durable ------------------------------------------------------------------------------------------------ https://www.youtube.com/watch?v=G8sSHdfbu1g https://www.youtube.com/watch?v=-Twzz8lBfEQ https://www.youtube.com/watch?v=PnE5ixD9iTE https://www.youtube.com/watch?v=bDyJXP4vEG8&t=906s ------------------------------------------------------------------------------------------------
Likes
8
Share
Doing amazingly! Actually started flush literally today! So stay tuned to see how chunky these flowers are going to get! They smell delicious! Candy shop in my tent with all these flavours!
Likes
37
Share
It’s warming up outside so the a/c and dehumidifier are working a bit. Got the lights on during the night so just a few hours at lights on they work a bit hard. Cleaned up underneath removing any sucker shoots and leaf that was near the soil. Not much really. Mostly on #3 as I didn’t train out the branches as much and she grew tighter together, so I removed mostly all inner growth blocking light and that allowed a lot more penetration and flow. Left a few leaves below to die off naturally…more the better. Gonna put some Grub Grenades in the pots with some yellow sticky cards. Not because I see anything, just being cautious. I do see what looks like Springtails but don’t seem to be an issue yet. Still looking green and healthy so I’m happy! Grow on! Update Made a few adjustments. I let the tops grow into the tsw2000, 18” to tops. I didn’t like how they looked so I raised it back to 24” where I’ll keep it. The “Kind LED” I know from previous grows that it can’t get closer then 24”. But this is my first run with “Mars” so I’m still figuring out the distance for my setup with additional overlapping light intensity from other lights. With that being said another pod failed so I’m down 2-Kind LED’s now. Gonna remove all old tech and use all newer TS series lighting. All Mars moving forward. Seems to be a great light and when compared to other quality lights you can’t beat the price!
Processing
Likes
12
Share
Ahora con el trasplante , empezarán a estirar bien, las raíces respirarán mejor. El sustrato es plagron light mix
Processing
Likes
10
Share
@BodyByVio
Follow
This week I top all 8 Green Poison ( 4dwc and 4 coco ) clones. They look healthy and happy and few days later I already start to low stress training (LST) them.
Likes
52
Share
@MeaCulpa
Follow
Hey everyone. I made one video with flash and one without as last week. So far everything seems to be good. The buds look very impressive. I never expected it.
Likes
7
Share
All good I think Tell me if you see some wrong please!!!♥️And more ♥️Stay save and healthy!!!