The one in the middle is struggling a little, but I'll just keep it and see how it turns

Adaptándose al cambio de ambiente

Flush time.

Smells dank in here

Esta semana blue moby y whithe widow vienen 10/10 (blue moby está en preflora) pero moby Dick viene media decaída estoy fallando en el stress o algo que voy tratando de solucionar (tuve quemaduras por el riego y defolie hojas en mal estado) . Empece con el scrog (es la primera vez que practico está técnica y acepto criticas y concejos)

Absolutely blown away by the new 2025 setup, prev ran 3 tents 😂, switched to AC Ifinity 2,4 x 1,2 single tent, 3 x 150 or 6“ fans. Fans all port outside, 2 exhaust with yet uncoupled carbon filters, 1 inlet with pollen filter. 6-7 air push fans (not all yet on 😂). SpiderFarmer 16L humidifier, inkbird RH control, inkbird heat control, heater, trotek dehumidifier (12L) with drain line and reservoir. Blumat system with RO fed 20L water butt, each pot with 3 long ceramic blumats. Data logger from SensorPush including WiFi hub and 4 sensors. One in cellar room (lung room), one above each plant canopy. Setup logger n sensors and track VPD. System running itself

The girls took off after some training and topping. I broke a stem training the green crack so I had to make a splint for her. I’m also noticing the leaves starting to like pinch at the bud sites. I read that this may be wind burn? Help.

Week 4 seemed a bit slow at first, but i also realised that I wasn't treating coco appropriately, I should feed nutrients every time I water and control the ph and ppm better. By the end of week 4 I got a water quality tester and am now able to properly take my ph down and monitor ppm so my plants don't get nutrient burned, but still gets enough nutrients in time. I also allowed good amount of the top layer of my coco to dry because I mixed up advice that received about soil and coco together. Apparently coco has no issues with overwatering unless your pots have no drainage so in the last 2 days I started treating coco the way it's supposed to be treated, I also finally got calmag and my plants are showing good signs of health past 3 days, they look revitalised and happy again 😊 Unfortunately, apple fritter was way too sick for me to continue with it so I restarted it in a proper coco and perlite mix that's non fertilised, that's a separate diary because its a whole month later. I decided not to train the first 2 plants just to see how the natural process is supposed to go.

Smell got more intensive and Ladies are more thirsty At day 8 of flowering we thought the plants are a bit too small so we gave them more space to the LED, about 70cm with 200watts Also they got 4ml/l of bioheaven

Weekly update for these 3 lovely ladies. They're progressing nicely and smelling like cake when you rub the stems. Did a defoliation this week giving them some more light at the lower sites. All in all Happy

Welcome Back!💚 Nach der dritten Woche entwickelt sich die GG#4 weiterhin sehr homogen und sie erreicht jetzt die 5 interniode. Da es sich um ein Indica Hybrid handelt, lass ich die Pflanze noch weiterhin Wachsen, da ich den Seitenaustrieb noch etwas weiter in die Höhe ausbreiten möchte Die Umgebungsgegebenheiten sind bis jetzt optimal: ————— 🌞 Temp: 23°C bis 24°C 🌚 Temp: 18°C bis 19°C 💨 RH: 70% VPD: 0,55 kPa👍 ————— Grüne Grüße 🥦

Ok I will Upload Pics from My phone ASAP, but I needed to go to the PC to write this faster, one of the plants that previously misgendered her as sativa was really an autoflowering plant showing her wild stretch! DAMN SHAWTY, thats so bizarre yet it's not as bad as it almost syncs with the change of photopheriod that was planned on 1st' Of October, SPOOKY TIME!. So the photos that happened between 27 and 31 september, shows that a plant was preparing for her flowering when she got in the mood, but i concern that now reducing my photopheriod to induce flowering on the other ones make these one the most wanky , less potent or less producer than ther siblings as in won't be in the best growing parameters.🤕 In terms of nutrient feeding , last Nitrogen Bomb before flowering, totally fine! here, as following action was throwing out some yellow leaves inspected as they block light for lower branche , and controling the plants height and wideness through diverse crude tools... involving Paper clips. 📎 Lights changed to more raw power and will be elaborated next chapter.💡 Night Homies!💨

Will update once dried and cured!

30/11/20 fue su primer dia de la semana 9 no pude subir foto 01/12/20 segundo dia de semana 9, se relleno con 4 cm de tierra aproximadamente . se sacaron 4 clones de la parte baja 03/12/20 hermoza planta, ya mide 74 cm de altura unas ramas satelitales muy largas se le corto algunas hojas bajas 05/12/20 en estas fotos estaba en sus horas de descanso 06/12/20 es su ultimo dia de semana se muestra muy vigorosa💪

💐💐💐💐💐 SCROG

I'm thankful for ditching the elastic style netting for a custom hard fence scrog. I'll note that the Hitop bubblers I'm using last about 3 runs, then they get loud and annoying and probably less effective. New circulating fan ordered and installed (no more clicking). Used that one for a lower deck fan.

Bienvenidos a este nuevo diario de Runtz patrocinado por ZAMNESIA para la Eternity Grow Cup 2025 Día -3 (09/01): Se coloca la semilla en tubo de ensayo con 15 ml de H20 Osmosis RO + 3 gotas agua oxigenada (H2O2) en un lugar oscuro a 25 ºC durante 24 horas Día -1 (11/01): Se prepara una maceta de 1L con sustrato PRO-MIX HP BACILLUS + MYCORRHIZAE Se humedece el sustrato muy lentamente hasta percolación profunda con H20 Osmosis RO Se hace un agujero de 1 cm de profundidad, se coloca la semilla con la radicula hacia abajo, se tapa con un poco de sustrato y se humedece ligeramente con agua en spray Se coloca parte superior botella / propagador en la zona de germinación para mantener humedad relativa alta y se introduce en el armario a 20 - 22 ºC (DLI 13 - 20/4) 💦 BioTabs 15% DISCOUNT code "GDBT420" biotabs.nl/en/shop/ @biotabs_official 🌱Substrate PRO-MIX HP BACILLUS + MYCORRHIZAE @promixmitch @promixgrowers_unfiltered 💡2 x Mars Hydro FC1500 EVO Led Grow Light (2024 NEW FC 1500-EVO Samsung LM301H 150W LED) - https://marshydro.eu/products/fc1500-evo-led-grow-lights/ - https://www.amazon.de/dp/B0CSSGN5D8?ref=myi_title_dp

Bruce Banners are stacking nicely under the 1100 PPFD intensity. Trichomes are already frosting up the sugar leaves, and the bud structure is looking very dense. I've added 90W of heat mats to stabilize root temps and improve nutrient uptake during this peak metabolic phase. After a heater failure last week, there were some temperature fluctuations that one of the plants handled worse than the others.

We plan to pre-flowering in next week. In this week we are stop topping in these girl. And make 160 cola per 1 plant and training with maintenance cut for Top bud every cola. We use compost tea and craft organic fertilizer to take nutrient to soil and plant can use it for flowering stage.