Hi growmies, unfortunately I skipped a day checking on the reservoir and the plant must have consumed a lot more water than expected, probably due to the heat we are experiencing where I live, since I realized tip burn getting worse everywhere I checked the ec, which was close to 3 😳, topped up with RO water right away and this seems to have stopped it. Other than that I don’t think it bothered the plant too much either, as she keeps on swelling bigger and bigger. A&B fertilizer was reduced already and once, either next week or the one after I’ll start flushing, depending on the stage of ripening.

Her buds are starting to get bigger. She’s shaping up nicely.

If you’ve got a bit of time and some ice, it’s really a fun thing to do. It’s also a great way to make use of every part of the plant

Can't get this plant really. Why it's already have so many yellow leafs? I choose to hate this genetics... I also have a lot of bonus seeds from this breeder and I'm going to check one or two on my next grow, but for now it sucks =(

Two phenotypes - one purple and one white/green. The purple was very difficult to train and resulted in a couple inadvertent breaks - luckily it was repairable. The other trained very well, very flexible and worked very good for SCROG. Both produced heavily and are beautiful. The purple tends to be much more fluffy, with very long pistil hairs - the longest of any grow I have done. The white was super dense, very crystally and sticky. It will be very interesting to see how they smoke. Also, the purple tended to do very well with some nute mistakes I made as well as fluctuating pH in my water feeding. The white did not do as well in this regard but was able to get to harvest fine. Wet bud weight is prior to trimming. The buds off of these plants were HUGE!!!! Plant #1: (Purple): Wet weight - 76.58oz prior to trim; 15 colas; Terps: White - 60%, Clear - 20%, Amber - 20% Plant #2: (White): Wet weight - 71.65oz prior to trim; 16 colas; Terps: White - 70%, Clear - 30%, After 3 days of drying, took them down to trim for my jars. After a few hours filled mostly quart jars 3/4 full but also tried an Infinity jar and a gallon mason jar to minimize the number of smaller jars. Dry weights into jars: Plant #1: 14.79 oz Plant #2: 11.76oz I did pull them after a day to dry rack them for 12 hours due to a little bit higher moisture content then I would have liked ( 70%rH). Re-jarred on 6/1/23 and now holding steady at around 60% rH. Cure Check In (Week 2): 6/10 - 6/12/23: rH ~ 63 - 66%. Daily air exposure & fanning. Very smelly. Looking good - another couple weeks and will be ready.

Last defoliation and final round, next week I will flush

to be updated soon

Photo coming soon having trouble uploading.😑 Trying again. The guys are holding up well to stress of over wintering they should start to perk up now,increase water,and temps rising. Hopeing to pollinate a choice female or two. Do some hunting for a prize winner!🙏

Les semis se portent bien 🙏🏻 Voilà maintenant 7jours qu’elle sont en pot 05/10/24 J’ai mis un compteur, j’ai actuellement 41 watt de consommation 37 pour la lampe et 4 pour les ventilation Box terminé, lampe fixer et ventilation mise

Still cooking strong. Did a heavy defoliation after these pics. But really just letting em be crazy ha. This strain is super hearty, excited to see what the next few weeks bring. Really starting to show signs of flower no been on 12/12 for about 10 days. Thanks for stopping by and as always 🍻

~ FASTBUDS TESTER #2204 ~ Well friends, here we go on another 'canna-venture' together! The grow room has had a complete remodel and some upgrades done to it including brand spanking new 4x8 and 4x4 tents and a Trolmaster Hydro X controller along with a new Control Panel. This tester strain is one of six tester strains that FastBuds has graciously provided me with and I'm looking forward to seeing what this girl has to offer when she's grown to her full potential! One drawback of 'testers' is I have little to no information on it other than its number and that it's an autoflower... 🤪 But, it's ALWAYS a blast growing them for me because not knowing a lot allows me to just concentrate on the essentials: Light, Environment, Water, Nutrients and possibly a bit of LST... not complicated, just basics like keeping a constant temperature and RH in the tent at a level that gives a good VPD, watering when almost dry and maintaining proper light levels according to their stage of growth. ____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________ ~THE SETUP~ ~Initially seeds were lightly scuffed, then soaked for 3 hours in 78℉ distilled water after which they were transferred to moist paper towels laid out in a Jiffy Pellet plastic starter tray with lid. Underneath the tray was placed a Vivosun Heat Mat with Controller that was set to 78℉ where they stayed until their tap roots emerged. ~Planted into Jiffy Peat Pellets that were hydrated with distilled water warmed to 78℉ with a 7.0 ph. ~Once roots emerge from the Jiffy Pellet they're transferred to their fabric pots. ~Grown 100% organic in a 4g Gronest fabric pot and a 3g fabric pot by Wraxly filled with Mother Earth 70/30 Coco/Perlite medium and initially amended with Dr. Earth 4-4-4 / Earthworm Castings / Dr. Earth Flower Girl 3-9-4 and Coast of Maine Stonington Blend Organic Plant Food 5-2-4. ~19/5 light cycle for the entire run with supplemental UVA added during flower. Lights are controlled by a Trolmaster Hydro X controller set for a 15min Sunrise/Sunset simulation. ~Top dressing every 3-4 weeks with slow release dry amendments and Earthworm castings. ~Straight water ph'd @ 6.2-6.8 when needed and bi-weekly Compost Tea's. ____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________ Weekly Updates: 12/1- I soaked both seeds for 3 hours in 78℉ distilled water after which they were transferred to moist paper towels laid out in a Jiffy Pellet plastic starter tray with lid. Underneath the tray was placed a Vivosun Heat Mat with Controller that was set to 78℉ where they stayed until their tap roots emerged roughly 24 hours later. 12/3- Today their tap roots were about 1/2 to 3/4" so at 11 am I transferred them into Jiffy Peat Pellets that were hydrated with distilled water warmed to 78℉ with a 7.0 ph using a tine off of a plastic fork as a 'mini trowel' to make a hole in the pellet and to gently cover the tap root, leaving only the seed head slightly exposed. This method accomplishes most of the initial work the seed has to do by eliminating having to orientate itself, push it's root down and head up. By 10pm the #1 seed had her cotyledon leaves opened and the #2 isn't far behind! 12/5- Well this is the full Day One for the #2 FBT #2204 and the second day for her sister! I'll keep them in the covered/heated Jiffy tray until I see their roots beginning to emerge from the peat pellet, then I'll transfer them gently into their respective fabric pots. The #1 will be going into the 4g Gronest pot from FastBuds and the #2 will reside in a 3g pot by Wraxly, which I'm trying out for the first time. 12/7- Yesterday I checked the #1 tester and she had roots starting to emerge from her pellet so I transferred her into her 4g Gronest pot. After making a hole in the medium for the peat pellet, I coated the entire surface with Xtreme Gardening Mycos then placed the pellet in the hole and planted her in. Lastly, I watered her in with about 4oz of de-chlorinated water with 3ml/g of FishShit added which was then ph'd to 6.4 @ 75℉ after which I placed a humidome over her for 24hrs to ensure that the humidity stays constant. The #2 tester is doing great and I'm confident that she should be ready to transfer into her fabric pot in the next couple of days! 😎💚 Thank you for checking out my passion in life! Please visit as often as you wish and I hope you enjoy this journey as much as I know I will! Grow Strong! 💪😎🤙

Patagonia

So Tuesday will be the end of week 8 of flower these are mostly ready to take but I’m gonna wait a few more days. I like a bit more amber than most.

Semana 7 FLORACIÓN 🌼

I have harvested my ladies. The buds are nice and thick. I'll definitly do an update on the drying and curing. I have already done some rough wet trimming. I am planning to do some more once it has dried They are now drying in my garage with a dehumidifier.

She was a delight to grow. Alot of trichomes and a heavy smell.

They looking good, but temp is a little too high. It is what it is One of the plants (In front to the left) is more frosty, with less amber pistils. But overall the trichomes are starting to go from crystal to cloudy. Which is my timing for start flush. 24/7 -Temp 23-26day/21-24night -47%RH (2+-) 25/7 Water day* start of flush Gave them till run through with plain ph balanced water, and topped it off with some light nutrients-mixed water. -Temp 23-26day/21-24night -49%RH (2+-) 26/7 -Temp 23-27day/21-24night -47%RH (2+-) 27/7 -Temp 23-26day/21-24night -47%RH (2+-) 28/7* Water day / flush -Temp 23-27day/22-24night -47%RH (2+-) 29/7 -Temp 24-27day/22-24night -47%RH (2+-)