Germination was successful in 24 hours!

June 7 - We ordered some new lights last week, they are 240w kingbrite samsung lm310h with uv/ir, 3000k, and meanwell drivers. We setup the new room and moved the girls into there. After a bit of LST and a watering (with nutrients) at roughly 7ph, they were ready to go under the 2 new lights and the same SF-1000 we have been using in this grow. The new room is a 12 ft enclosed trailer. I moved everything from the small tent into this. I put clear poly on the walls, floor and ceiling. I put poly on the shelf I am going to be keeping in there as well. I bought 50ft of 6mm mylar and lined the floors, roof and sides with it. I plan to get some reflective tape to seal everything and to cover the wood. I did not get much of a chance to watch temp's today as they it was later in the evening after all was said and done. The inline fan blowing in air from outside. June 8 - 9 AM i checked the plants, they were at 25.2 and 50% RH. Late through the day I had checked and we had gotten up to around 32 degrees. So I moved the inline fan to the closer vent, hooked up to that, and had the air blowing out of the trailer with the inline fan sucking it from above the lights. I then added oscillating fan and had it blowing air on the left side of the room so it would somewhat circulate once I closed the doors. I then checked at about 9pm and we were at 22 degrees. Definitely noticed a decent amount of growth already. I have the lights on a 22/2 cycle as I was worried about the heat at night time. June 9 - Some great growth from the girls, still having problems controlling the temps in the afternoon. I decided to prop the door open a bit to have a constant breeze throughout the day while I am at work. Decided to do some more LST and also a bit of defoliation. I took about 25% of the leaf's that were blocking the new growth as it was getting a bit bunched up. I was then told the leaf's are almost solar panels for them. So from now on I will be trying to just do some tucking unless needed. The leaf's I removed were most of the damaged leaf's, I am not to sure if that makes much of a difference. I gave them a watering with only water as there is a potential I am getting a bit of a nutrient buildup along with the PH problem. Or potentially the reason for the ph problem is nutrient buildup. After watering with A PH of 7 I got some run off and tested it. The smaller plant gave me a PH of about 5.5 where the bigger one is around 5.0. June 10 - Plants are looking happy and showing tons of growth. Seems to be trying to stretch outwards. Not a ton of sign of PH issues showing so potentially getting it under control. Still a bit of damage to previous leaf's but it is what it is! The last few days I have been leaving the door open a bit in order to keep the temps down. I decided to test something and turn the lights off (automatically) at 11AM and back on at 5PM so light schedule has now changed to 18/6 and it seems I may have figured out the issue. We haven't had lots of sun the last couple days so it hasn't been to hard and I have yet to know if it truly fixed the heat issue for now. (I will be looking into a ac unit as well since it typically gets to around 30-35 around here. June 11 - Pulled some of the branches back down and added a few more LST spots. Seems we have a good amount of growth from the smaller plant out of the 2 topped spots. Unfortunately it looks like I fucked up on the bigger plant and only one of the nodes seems to have new growth. I will continue to monitor that but I think I cut the node to low and also to soon. Other then that, the girls are doing great. They seem to be absolutely loving these new lights. I gave them some nutrient water today as well. roughly 3L each. They seem to be A hell of A lot more thirsty under these new lights. June 12 - The girls are doing great , they are still just doing growing away. Lots of progress everyday. I am going to be getting a go-pro so I can set-up a time-lapse for the rest of this grow. I received my new inline fan, I got A ac infinity CLOUDLINE T4 with the temperature humidity controller. I am going to be having one fan pushing fresh air in and one fan pulling out the hot air. I will be doing that tomorrow since I have to work today. June 13 - I ordered another 50ft of mylar and that showed up today. I have decided to remove the shelf and add another 3+ feet to the grow space. So today I installed more poly, mylar, the ac infinity fan. I have it set-up to pump in air if it gets to warm. I am thinking of switching it to the output that way if it gets to hot or to humid I can have that air pulled out of the trailer. Right now my other inline fan is the outtake and I just have it set on full. Overall I think everything is set-up a bit better and more accessible. I will be putting my 2x2 tent in there at the left of the doors so I can have a veg room when these 2 are in flower. I plan to have 4 in veg and 4 in flower for the next grow. Still waiting on JOTI seeds, ordered 3 weeks ago and still have not been shipped. I will be getting those going the moment they arrive. The girls seem to be happy still, did a bit more LST to try to keep everything even, mainly I'm just pulling down on the spots I already have tie wire on.

Welcome to week 8! My little apple fritter doing great! The buds getting bigger from day to day and she’s handling the small distance to the light fantastic. I think I have another 1,5weeks to go and I’m Herz curious about the harvest!

My Purple Kush plant is the smallest in the tent and hasn't been growing much. It's a classic strain, so I'm not sure why it's struggling. Maybe I just got a bad seed. I'm still hoping it'll turn purple and delicious, though! Okay, This past week has been absolutely fantastic! The weather has been incredible, and I've been able to keep the windows open almost the entire time. My plants are thriving in the humidity, and the VPD has been perfect. Everything just feels so balanced and in check.

Görsel olarak hoş renkleri ve güzel bir hoş kokusu var onu denemek için heyecanlıyım

Tag 62

Hi Guys. Here we are starting week two, the news is: - My 60x60x140 Senua tent, 3gl pots, VIPAR P1000 Light, and the fan have arrived. So, two of the little ones I put in the new pots, the other one I will try to grow as a Bonsai, the bonsai pot will arrive in two days, so I am really excited to start the bonsai project, I am thinking about creating a Diary for that. :-) The biggest one (in the photo) is showing some yellow parts in the leaves, is that an issue? Another question, I used the Nutrients as the information on the label, is that too much? Thanks guys, I will appreciate any help :-)

Día 6 (29/04) Spray solo agua el top del sustrato. DLI 13 Día 7 (30/04) Spray solo agua el top del sustrato. DLI 13 Día 8 (01/05) Spray solo agua el top del sustrato. Subo a DLI 17 Día 9 (02/05) Elimino la cúpula casera de humedad y empiezo a regar con 300 ml solo agua Día 10 (03/05) Empiezo a luchar con una ola de calor inesperada para esta época, que me trae temperaturas exteriores de 30 ºC y humedad relativa del 30%... Mantengo la cúpula casera de humedad Día 11 (04/05) Hace muchísimo calor.. 30 °C. A ver como lo llevan Hago un invento casero para aumentar la humedad Día 12 (05/05) Primera alimentación con Aptus! 300 ml H2O + Regulator 0,15 ml/l + CaMg-Boost 0,25 ml/l + Startbooster 0,25 ml/l - pH 6.2 Creo que las plantas se ven un poco pequeñas para tener 12 días... esperando por explosión de crecimiento en los próximos días.... 💦Nutrients by Aptus Holland - www.aptus-holland.com 🌱Substrate PRO-MIX HP BACILLUS + MYCORRHIZAE - www.pthorticulture.com/en/products/pro-mix-hp-biostimulant-plus-mycorrhizae

She's looking very healthy and getting bigger every single day nonstop, she's growing very fast, love the beautiful green color she has, think I'm gonna enjoy working with her in this indoor run! Let's see what we can do! 💚 🌱 ✌️ 💎

Checkout my Instagram @smallbudz to see the Small budget grow setup for indoor use, low watt, low heat, low noise, step by step. 27/02/2020 - Gave her 1.5l of RO water.

We are in Flush !! Was giving them GH Flora series + rapid start + cal mag

Welcome Back!💚 Nach der fünften Woche des Wachstums entwickelt sich die S Apple Apple durch das topping etwas gehämter. Scheint so, als hätte sie das nicht so gut vertragen / kann aber auch sein, dass ich sie zudem etwas Überwässert habe. Daher habe ich die Pflanze nun ein paar Tage nicht gegossen und langsam erholt die sich etwas. Allmählich ist eine reguläre Triebform erkennbar, dennoch bilden sich die Triebe sehr langsam und eng anliegend aus. Daher habe ich ein paar Beugungselemente an die Seitentriebe angebracht. Sie fasziniert mich sehr und ich bin so gespannt, ob sie dann auch ordentlich so die Triebe ausbildet. Ich bin gespannt, wie sich die Pflanze entwickelt. Diese Woche habe ich die Pflanze zudem noch mit Orgatrex gegossen.. Die Umgebungsgegebenheiten sind OK: ————— 🌞 Temp: 21°C 🌚 Temp: 18°C bis 19°C 💨 RH: 54% VPD: 0,85 kPa ————— Viele Grüße 👋

*Week 1 Seedling/Veg - 09/25* So far so good, Mimosa one had a little slip with her first set but has since recovered accordingly and is filling out nicely. High Temp 82-85 - High Humidity 90 - 94% *Week 1 - Veg 09/28 update* 2 of the 3 seeds failed due to user error - currently only running girl, she is coming along nicely. Transplanted into a small container using coco. * Week 1 (Early Veg) update - 09/30* Thus far all is moving accordingly - Added some light myco to the coco and running in prop dome at 91% humidity and 81 degrees in temps. Light watering until the final transplant

New tent + new light (not install on this session)

Hi there! I'm so satisfied of results until now. Third Generation SPEED AUTO has a growth fast and vigorous, thanks to Rhizotonic support also, what gives them necessary boost to the increase.😎

MrJones VIPARSPECTRA XS1000 LED 📜 SUMMARY - I have been given the opportunity to run the next generation of LED lights by VIPERSPECTAR, the XS1000! I set up a Stealth Cabnient and moved 3 Cream Manderain Auto XL.s under these lights, the cabinet set up is automated with WIFI light controllers, and INKBIRD Temperature and Humidity Controllers, I am very excited about this opportunity! Specs and Discount Codes Listed Below. 🔹🔹🔹🔹🔹🔹WEEKLY GOALS 🔹🔹🔹🔹🔹🔹 🌞Environment - 80F and 50%Humidity - using Humidfyer as needed. 💧 Feeding - Feeding with FOOP Canna Organic Nutrient Line 🍃Training / Keeping Stems Stable and Strait 🕷️ IPM - Will be using Green Cleaner" 1 OZ per Gallon, and CannControl from Mammoth alternating between product each month for Integrated Pest Management. 💡 Vegetation & Flower (new) Viparspectra XS-1000 Release on March 15th. 🔹🔹🔹🔹PLANT UPDATES🔹🔹🔹🔹🔹 🌱 Plant #1 - Week 5 Flowering is starting to happen, should see more stretch this week, she is about 15 inches wide not. 🌱 Plant #2 - Week 5 Flowering is starting to happen, should see more stretch this week, she is about 12 inches wide not. 🌱 Plant #3 - Week 5 Flowering is starting to happen, should see more stretch this week, she is about 12 inches wide not. 🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹 ▶️Monday 03.23.21 / Plants are starting to flower, I decided to defoliate and remove many of the small sucker branches, I would prefer the hormones being spent in the larger and more productive colas, I also fear that these plants may outgrow their space, we will see,I am moving the feed up to the next level as well. I am amazed that just at a week under these VIPARSPECTRA XS1000 LEDs they have almost doubled in size, the FOOP Canna nutrients are so easy to use and the plants just love them! ▶️Tuesday 03.24.21 / These girls just keep stretching, not much room left under the lights feeding FOOP 30 ounces each day. ▶️Wednesday 03.25.21/ Feeding FOOP 30 ounces per day. ▶️Thursday 03.26.21 / Feeding FOOP 30 ounces per day. ▶️Friday 03.27.21 / Feeding FOOP 30 ounces per day. ▶️Saturday 03.28.21 / Feeding FOOP 30 ounces per day. ▶️Sunday 03.29.21 / Feeding FOOP 30 ounces per day. 🔹🔹VIPARSPECTRA XS1000 LED🔹🔹 Amazon US: XS1000 10% off: in10MrJones http://yx-8.cn/0y-6 XS1500 5% off: in15MrJones http://yx-8.cn/0yA XS2000 5% off: in20MrJones http://yx-8.cn/0y2Y XS4000 5% off: in40MrJones http://yx-8.cn/0y5k Amazon Canada XS1000 10% off it10MrJones https://amzn.to/38udUVe XS1500 5% off: it15MrJones https://amzn.to/3esVUyr XS2000 5% off: it20MrJones https://amzn.to/3l5zAfg XS4000 5% off: it40MrJones https://amzn.to/3l7k5Uj