Week 9/Semana 9!

Hello people... So heres the new strains Gellato 41 by SEEDSTOCKERS. New setup with Heavengrowlights 320w, lets see hoy they do. left a couple of timelapses for the germination process cheers feel free to coment

Week 6 of flower - At the end of this week I defoliated down to mostly bud and sugar leaves for the final stretch. I fed them normal with no HP2. Feed this week was 1.25 gallons two times with about 4 days between. 750ppm total before add-ins. I used 750ppm Bloom concentrate mix (recipe week 5). However, I also added 1ml/gal of CaliMagic (General Hydroponics 1-0-0) to all feeds. PH balance this week was 6.3. Next week I will add the HP2 back again while reducing the nutes for flush.

10/12/22 watered with nutrient water. PH 6.6 TDS 400 10/15/22 mid-week plant is rebounding nice.

Finally getting all caught up here. Sorry not more details, but the dates on photos are accurate from iPhone timestamp. Skipped a few nutrient feedings due to still fighting what I thought was a ph issue, so we’ll see how she reacts to being fed on 11/19.

1 plant was very ripe, 1 plant was almost perfect to harvest and the 3rd could take another 1-2 weeks...but it was end of 10th week of flower and i had to go on vacation, so i perhaps choped 1 plant abit too early....still awesome result!

Week 15! Nothing much to add. She is plumping up nicely. She is not using as much water as she was when the buds started forming. I can leave it for 5 days no problem.

Normally I allow two days in the paper towel germination. This one after only 24 hours.

Hello growers day 42 in the garden with the blue monster auto 19/7/20 all is well she’s looking really good just keep feeding her when the top is dry and she is loving life just hope this good weather iv been getting holds out for a bit longer so she can beef right up until next week be safe and happy growing ✌️

Wow things have been looking good so far, Really no problems.. Slow but I'm seeing the fruit the joy pop out of my ladies. So i gave Trina a cut after feeding very heavy as you can see in the pic. Ran out of Ph up and Gina ran Ph of smfh 5.6, that's all I'm going to say.. Cross my fingers also my Rh really been up and down. I'm going to fix that tomorrow.

Today is day 105 since the plants sprouted, and day 49 of flower (week 7). The plants look like they'll be finishing up nicely. I haven't seen any more pollen sacks or nanners forming on the Papaya Sherbert, and the buds on that plant don't look like they've been affected by pollen. The buds on both plants are hard as rocks, and still getting a little bulkier. The buds on the Papaya Sherbert (left plant in the tent) are getting pretty big, and I really look forward to seeing them after getting trimmed. The buds on the Orange Sherbert have definitely been smaller than the buds on the Papaya, but the buds still look nice. I think the Orange Sherbert naturally has more buds sites, however. Trichomes are developing nicely. The flower time on Orange Sherbert is 7 weeks, and I think it still needs closer to 2 weeks to form more amber trichomes, but the milky trichomes are looking great. The Papaya Sherbert has a 9-10 week flower time, so hopefully it lines up with the Orange Sherbet. The trichomes on Papaya Sherbert are noticeably behind, but not too far.

420Fastbuds FBT2310/Week2 Weekly update for these 2. I started seeing some rust spots so I decided to add a little General Hydroponics Calimagic at 0.25tsp/gal to my feed. So far seems to stop. I also decided to start a very light dose of nutes General Hydroponics 3 part flora series at the same 0.25tsp/gal to every other feed to see how they'll respond. All in all Happy Growing.

tomorrow defoliation

This is the tester strain sent to me by @toon_town it's a #saskatoonberry x #afghani mystery .. She has been great since day one very good growth rate excellent structure and lots of bud sites formed and filling out .. she has 7 friends to start but we down to three two females and a male plant .. The selected male show resistance to cold, humidity, lack of water .. the male had lots of growth and will make a suitable plant for some pollen ...

Week 2 going 💪🏼 used fish shit and water

Flower is in its last week might push another half week out but i already stated flush at the beginning of the week as you can see the chlorophyll beginning to flush out ☃️😋🎄

Finally the stretched stopped. Cut about 10 tops bent about 20 with 90s. Still right in the lights. They are looking very happy even though they are so close to the light ( thanks to high c02 levels most likely.) Another week or 2 before I cut the temps and co2 levels down. Been trimming all leaves below light line. Stinky and brutally sticky I feel like Clark griswold with pine sap when ever I am bending the tops and such.. I think even with them being in the lights I will still get a few pounds of premium flower to smoke :)

New week for the 3th grow It's getting along very nicely must say one is looking better then the other and it's mix bags of sizes to worry about but other then that no troublesome issues what so every Next week going to lower the nutrients and be going into overdrive for next 2 weeks and probably be flushing some after 3 weeks Happy growings Growmies 🤜🏻 🤛🏻 visit www.marshydro.eu for your best gear and use the PROMO CODE: DEVILSBUD Some info about the Marshydro FC-4800 Superb Quality LED Chips: The whole light is composed of 1206 pcs Samsung lm301b and Osram 660nm chips. More than two times as many LEDs are used to drive the grow lights at low currents and to avoid overdrive. Quality is guaranteed and efficiency is up to 2.8 μmol/j. Even PAR Distribution and High PPFD Output: The multi-light bar design and the densely distributed light chips enable the LED grow lights to achieve the optimum PPFD required for plant growth over the entire effective coverage area. Specifically Designed Spectrum: To ensure even plant growth, blue and red light are enhanced on the basis of a full spectrum combination. Not only does this accelerate plant growth, but it also improves the yield and quality of the plants at the same time. Dimming Daisy Chain Function: The dimming function saves on electricity costs and enables brightness from 10% to 100% for the different stages of plant growth. A single master light can connect up to 30 lights in a daisy-chain system. Business LED Grow Light: The light's wavy heat sink dissipates heat quickly and the IP65 waterproof allows the light to operate in humid conditions. 180° collapsible feature for easier installation. All these features provide favorable assistance for commercial cultivation. And some tent info ●【Lock All Light Insid】MARS HYDRO Grow Tent Interior is made of diamond mylar. Non-toxic to the environment, no harm to plants. High-quality 1680D canvas being double stitched, (ALL OTHERS BRAND grow tent is 601D canvas) which is tear-proof for perfect light locking, No light leaks or rips at all. ●【Durability Grow Tent】Stable Metal corner adapters and poles are the trustful supporters of the tent. No rusting nor paint-falling. Quick easy tool-free installation. Carries strong heavy-duty SBS zippers, double layer lining to create a light-proof seal. ●【Easy Observation of your Plants】Special peeks window made by double layers of cloths. Observe the growing conditions of your plants without opening the tent and avoid disturbing plants. The peek window also serves to dissipate heat and ventilate air. ●【Removable Tray Keep Clean】The package includes a removable waterproof floor tray to hold soil and fallen leaves. The tray can be taken out easily to wash. Removable and water-proof makes cleaning easy. ●【Good Ventilation&Fast Assembly】 Circular double-sleeved vent holes with adjustable nylon strap for air circulation by exhaust fan, ducting, carbon filter, or reflector. Better allows proper light, heat, and airflow. Quick tool-free installation. Reinforced by a sturdy metal frame to ensure security and stability, supports up to 140lb. Perfectly safeguard your plants to thrive even in winter