Likes
6
Share
@Hashishi
Follow
Lemon tree strain is growing big for a seedling
Likes
12
Share
This week I assembled the new 48x48x80 Mars Hydro tent and installed the new FOHSE Aries 600W LED light. I set the dim to 75%, but after two days, it was clearly too much, especially for 20 hours per day. I will dim it way down and shorten the hours until the plants appear to be doing better.
Likes
4
Share
@xipo86
Follow
Day 69 Buds gettin heavy by the day. it's only a matter of waiting now. frost from apolo haze is crazy. Super boof is gettin there now but apolo.... will be a frosty one
Likes
5
Share
Too much N is observed and also some heat as there is an heatwave again and inside the tent it was around 31 c°, i only used half dosis of iguana grow in a light mix and it still seems to be too much, the ppm was around 380 so not sure if its just heat stress, but i think they will be fine, i will just only give water the next week and apply some slow absorbing nutrients on the top of the soil, something like guanokalong or biobloom, im sure they will be fine 😁
Likes
11
Share
She seems with Potassium deficiency but the addition of more bio nutrients and the additional seems to have kicked in. Also the cheese terpines have kicked in and I personally prefer WC only, but maybe that changes my mind later on.
Likes
1
Share
Absolutely blown away by the new 2025 setup, prev ran 3 tents 😂, switched to AC Ifinity 2,4 x 1,2 single tent, 3 x 150 or 6“ fans. Fans all port outside, 2 exhaust with yet uncoupled carbon filters, 1 inlet with pollen filter. 6-7 air push fans (not all yet on 😂). SpiderFarmer 16L humidifier, inkbird RH control, inkbird heat control, heater, trotek dehumidifier (12L) with drain line and reservoir. Blumat system with RO fed 20L water butt, each pot with 3 long ceramic blumats. Data logger from SensorPush including WiFi hub and 4 sensors. One in cellar room (lung room), one above each plant canopy. Setup logger n sensors and track VPD. System running itself
Likes
10
Share
Day 43 : Watering with co2 tab / 5L. Also added food again because i think they need it. Increased ppm to 850. Maybe the next one will be pure water. Ventilation works all the time when lights are on. Temp and humi are stable and this is good for the girls. Although she is indica, she still grows. 9 cm in 3 days. So i guess this is the reason her buds are a bit behind. Patience is the key always. Also removed some burned leaves from all ladies. Edit (Day 47) : Watering with co2 tab every 5L. I watered with juices again at 850ppm because i felt that they need it. Only WC drank pure water because of burns. She grow 13cm in 4 days. An indica pheno stretches like she is in preflowering stage. And this i think is happening. At start she took a lot of air and maybe she felt cold. So, now she started again to develop. I make a prediction that her buds will be really fat. She is very healthy and responses absolute perfect to the nutrient schedule.
Likes
37
Share
@GYOweed
Follow
Harvested after 3 days flush and two days night after recommended 9 weeks. Got 2 phenos. One better and more representative of the strain description which i kept a clone of to S1 and stabilize. As usual uploading here is a pita it didnt upload my videos again really annoying, but pics show the better strain is stronger bramches, stretchier, and better buds. I cut them in the video so no one cries i didnt harvest lol. Smell is from sourish sweet to sweet and mossy like a green slurpy or something. 6 week testers were potent and frosty already so i cant imagine after proper harvest and cure.
Likes
19
Share
07/05: made LST and Defolation New res EC: 1,13 PH: 5,8 I'm only adding PH- for now.. PH usally raise and EC remain constant Installed carbon filter and an additional air extractor
Likes
4
Share
60x60 cm tent in a 1920's peek-in-closet Oversized vent for silence High power DIY LED True SoG 12/12 from seed with 15 plants in 2L pots Watering all plants in bottom tray with 30% of total pot size (10L) WEEK 1 DAY 1 - Germinated in paper towel DAY 3 - Planted into pots + Lights ON at 125w DAY 5 - All plants have broken soil DAY 7 - Slight stretch - Light at 185w WEEK 2 Two of the Iced Out are lagging behind, others are on point - I'm trying to push light and nutes to the max. Extraction fan (AC infinity Cloudline T6) on level 2. DAY 13 - First full watering (10L) with 20 ml Canna Terra Vega DAY 14 - Circulation fan turned on (low) during lights on WEEK 3 Good growth, two Iced Out still lagging DAY 18 - Light at 225w, Extraction fan on level 3 during lights on DAY 20 - 2nd watering, 8L with 30ml Vega + Light at 250w DAY 21 - On point, mostly :) Could've pushed nutes a bit more from the go WEEK 4 DAY 24 - So far this week I'm just kicking back and watching them do their thing. The two lagging Iced Outs are trying to catch up. DAY 26 - Watering 10L with 50 ml Vega (one day too late...) + light on 300w (max) DAY 28 - 4 weeks from popping the seeds, looking good except for the two Iced Outs, one of them is trying to get with the program, the other... Well, some plants are just pricks.
Likes
30
Share
@Tazard
Follow
Doing great this week. I’ll try and get some elevation photos next week to show the branching. These seem to be a very vigorous cross.
Processing
Likes
18
Share
@KemoSace
Follow
Added CO2 suplimentation and up'd the nutes to 900ppm today; the runoff was 230ppm which means the plants appreciated the additional nutes & drank good; today's feeding of rain water, cal-mag, floraMicro, FloraGrow & FloraBloom was at a pH of 5.5 and the runoff pH was 6.6 (All exceptional numbers IMO).
Likes
141
Share
Как-то незаметно мы уже пересекли условный экватор, и пока всё ОК. Очередная сломанная магистраль намекает от том, что пора прекратить подгибания, хоть экран до конца и не заполнен, как я планировал. Включил боковой доствет, теперь у меня горят все лампы😎 В третий раз дал Delta9(повторно по листу). На новых листочках появился первый "снежок"❄️ Собираюсь убрать всё лишнее, когда растишки остановятся в росте, а пока остаётся только ждать и наблюдать. Спасибо, что заглянули, и будьте здоровы! 🙏 Продолжение следует ...😶
Likes
28
Share
@Roberts
Follow
The smaller Potter of Gorilla Glue is doing okay under the Spider Farmer G3000 light. The nutrition is a little strong for her, but I keep flushing the ph back up every few days. It's not causing any issues anymore, but needs to come up more in the substrate for flowering better. She had a selective defoliation done and fed. Then I placed her back in the tent. Thank you Spider Farmer, and Amsterdam Marijuana Seeds. 🌱🤜🏻🤛🏻🌱 Www.amsterdammarijuanaseeds.com Thank you grow diaries community for the 👇likes👇, follows, comments, and subscriptions on my YouTube channel👇. ❄️🌱🍻 Happy Growing 🌱🌱🌱 https://youtube.com/channel/UCAhN7yRzWLpcaRHhMIQ7X4g Spider Farmer G300w: https://amzn.to/3S2zvsd Spider Farmer 10X20 Heat Mat Kit - https://amz.fun/lsa0J Spider Farmer Amazon Store: https://www.amazon.com/spiderfarmer Spider Farmer Official Site: https://spider-farmer.com Discount code: saveurcash
Likes
7
Share
After 12 weeks of flowering and an incredible fragrance, I cut off the larger top blooms. The smaller ones that were covered will be given another 1-2 weeks to ripen. Incredibly beautiful colors, pink-purple-green colored flowers The larger fan leaves were quickly cut off. The scissors were covered in purple resin. The wet flowers were carefully sorted into the drying net. Now they can be dried in the dark at 19°C and a humidity of 50-55%
Likes
5
Share
@Enki_Weed
Follow
Der neue Chiller hat sich als absoluter Game-Changer erwiesen! Sowohl die Wassertemperatur als auch die pH-Stabilität sind jetzt perfekt. Ich habe 15 Liter Wasser gewechselt und die Nährlösung erneuert. Der pH-Wert ist stabil bei 6,1-6,3 und der EC-Wert liegt bei 1,95. Die Blüten sind förmlich explodiert und die Pflanze ist jetzt ein echtes buschiges Monstrum, randvoll mit Blüten. Ich bin gespannt auf die weitere Entwicklung!
Likes
90
Share
Do you think her leafs are getting fatter? how thick are they though, seriously ?? so thick ! that's that 100% indica i guess, really striking to see her asleep with those fat leafs isnt it? tried out the obscurity to try and get some nice in, hope you find them nice ! i really like that dramatic effect with the lighting and the shadow but to be honest i'm not the most talented photographer so i dont really know if it's working for you or not, so let me know ! she's growing as expected basically, squat, short, thick, doesnt really need that much attention, so far these genetics are an absolute pleasure to grow ! Raised the lights to the normal height, reduced the light schedule to 13/11, fed with some biocanna i had on hand, added some specialized flower micro : that's mag sulfur and cal mag , hopefully this will make the end product more pungent and more potent. let's see some flowers amirite?
Likes
2
Share
So i did heavy defoliation for light penetration and extra stretch in the middle of the crown. Took one graft and grafted on pretty abused multistrain Mother plant . Remove branches and did lollipoping. Everything under last 3/rd of crown. Giving more space for roots in 30L bucket. Also. I refilled 10L from 15L thru the week. Start at 6,0Ph and 1,8EC fed twice with same solution. Today Ph 6,7 and 1,4EC. Sne will be moved to bigger bucket and i Mix the old solution with New water and season it to 5,7Ph and 2,0EC with a plagron hydro A/B, hydro roots and pinch of great white mycco. She is 40cm wide and 25cm tall. I will pack her next saturday under the scrog net and switch her in bloom. 35cm light distance 900ppfd. For first two weeks to get mid stretch. At least 15cm vertically. 25 at most. Because of light penetration. I want 30 buds. Maybe using second scrog net is a good idea. With different eye sizes. To separate buds correctly. I will add more fotos of New bucket later. Its saturday valentines Day.
Likes
10
Share
@Smev1337
Follow
this is the end for this RF3 run with the Strawberry Gorilla strain! been really fun growing it but i need bigger stuff for next time 😎 i'm calling an monster grow 2.0 later this year! 😏👌 happy growing all! 😎✌️💚