👉The time finally arrived for the harvest, mostly cloudy trichomes with scant few amber, very few white pistols, and the leaves had either faded or were fading. The run-off pH would quickly plummet and the run-off EC would spike. This may be an indicator that the plant is ready but that only would be conjecture on my part. The overall look of the plant to me said it was ready. The aroma was super strong citrusy and intoxicating. THe leaves were fading and there were virtually no white pistols. 👉I harvested bottom to top. I hung each cola on alphabetized clothes pins with gardening wire attached for hanging on the rack. The buds are dense and shaped like pine cones. I trimmed it semi-tight, but left some of the smaller frosty sugar leaves. The buds and sugar leaves are very frosty but it wasn’t as scissor freezing as the Gorrila Glue I grew last year. I measured the post trim wet weight on a self-calibrating digital scale. I checked the accuracy of the scale with a set of scale calibration weights and it was accurate at all weight ranges. I logged each colas trimmed wet weight and hung on the rack. I have a 42” tower fan. For first 12 hours I ran it at its medium setting, then reduced to lowest speed. I rotated the side facing the fan after 24hrs. Then after another 24 hrs I placed them in paper sacks with to top open. I left the buds on the clothes pin hanger and clipped the bag to that. After another 24 hours I closed the tops. Another 24 hrs and I test weighed a couple of colas. I monitored for another couple of days until the weights averaged 20-25% reduced from the initial wet weight. I then cataloged the weight of each cola and placed each into its own jar, most got one of those small cheap hygrometers. These hygrometers have been calibration tested and I know the drift of each. My target humidity is 62%. I would open the jars for brief periods of time during the next couple of days until the humidity stabilized at 62%. Once stable I placed 62% humidity packs in the jars. I took out most of the hygrometers for the next plants cure, but leave some of them with the best buds. The Queen cola was 20g when placed in the jar. That is about 24% remaining weight from trim. 24% is a little on the high side of the humidity target range. The jar the Queen cola is in, is a wide mouth counter jar and I will be toking that bud primarily and it will dry out the fastest. I have compensated the weight I entered on the dry weight spec to reflect about 20g more of humidity loss and another 30 for the stems that are left on the bigger buds. The final weight of the buds going into the jars was 254g (not including the larf at 23gdry). 200g of plump sticky pine cones for the final weight is pretty nice for a 1 gallon pot. 👉I wrote this review at 3 weeks before the 6 week cure mark. In my short experience of being weed rich, its been interesting to take note of how the flower continues to ‘cure’ as time goes on. I have found that 6 weeks isn’t a given for when its ‘cured’. I have observed that as weed ages it changes. I have not noticed much difference with 2-3 week old buds at 62% humidity when compared to 6 weeks from jarring. But I do notice significant difference around 6 months of age. The flavor is enhanced and the buzz is stronger. It maintains this level then 8-12 months it has leveled off and all strains are becoming more ‘couch lock’ inducing. My observations are not scientific by any means. This is just my 8th plant in the 2 years that cannabis became legal for home grow in my area. But I still have each of the plants and rotate which one I consume. 👉I loved growing this plant, and hopefully gained more knowledge. It fox-tailed a bit at the end. I think my frequent fertigation techniques contributed to most of the issues I had. I think I was a little too conservative with nutrient mix and irrigation volume and frequency. I used only 10% expanded clay pebbles in the coco mix as opposed to the standard 30%. This was slightly problematic at first before the roots filled the pot. Fertigation events would cause erosion and caution had to be taken around the seedling. I placed a layer of hyrdoton pebbles across the surface and the issue was solved. Once the pot was filled with roots it took 10+ minutes to give the plant 2L of solution. The pot was packed hard with roots. This may have been a contributing factor to some of the possible nutrient issues I had. I dont think the nutrient issues I saw had much impact on the final outcome. To get 200g from a 1 gallon pot is wonderful.

She’s starting to get plumpy and frosty- toning down the nutes and switching to more micro nutes. Decent structure and smells very fruity- but that can change

4th week, stop root fertilizers and amino treatment.

I enjoy growing this strain so much that I decided to pop more beans and get another 2 plants going. It’s such an addicting aroma and beautiful strain to take care of and watch mature into plump fat purple nugs. I personally think this strain smells more like candy then anything else I’ve grown. Even Zkittles. This is a great strain for beginners or for someone lazy that just wants to kick back and enjoy the process. Thanks fast buds!

Dialin up nutrients and putting net over them this week to fill the space.

Got everything hung up. Stripped the fan leaves and broke down into sections. Run 60/60 or as close as i can get until the stems snap.

Wow this week was nerve-wracking. Her roots were well into the toilet part of the pot so it was time to remove all the soil and manipulate the roots for exposure later during the big reveal. Fingers crossed the makes it. Her being an auto it will stress her into flower but that's okay it's a cannabonsai they are supposed to be small. She still has a couple weeks of growth still so it will be just fine. The other plants in the shed are getting flipped to flower this weekend she I've put her in the tent with her sisters. Sorry about the blurple but hey.....it is what it is right?

last feeding,ripping for 1 week then harvest my 1st grow yea😎 they turnedcolor durning harvest moon!!!! added veido today

End of cultivation of a landrace, probably Manga Rosa, due to the smell and flavor, in addition to other characteristics (sativa, long-flowering, style of flowers). 3.7 liters (1 gallon) = 58 grams / 2.04 oz (flowers without branches) Using 120w lm301h-evo, together with another plant in the same environment. Last week just water, two small flushes, to clean the soil a little, but nothing excessive. 7 days drying, dark, well-ventilated environment, without direct wind. And now cure for at least a month, trying a little each week. I killed her when she was 93 days old, with 12 hours of light from the beginning, it seemed automatic. Because she is almost or completely sativa, perhaps another 2 weeks could be good for her, but I wanted a cultivation period of around 3 months, which was cool, but I believe that for a 90-day cultivation period, it is better to use some hybrid or indicates, as they develop faster. Sativas are aggressive in their expansionism and slow in flowering. Leaves and branches saved for later extraction, probably ice hash.

Today marks the start of Week 6, Day 2 for the grow, and I’ve got a few updates. The PPMS aren’t quite where I want them after the last couple of feeds, so I’ll be continuing with higher feeds to bring those levels back up. It’s a bit of a balancing act, but I’m staying on top of it. I also made the decision to flip the light schedule from 16/8 to 12/12 today to initiate the flowering phase. I’m excited to see the plants start stretching and showing their full potential. It’s a big step, and I’m feeling good about the direction things are heading. Happy growing! 🌱💡🌿

All the photos are in the 8x8 now. just a few autos in here now FOR EVERYTHING MARS HYDRO VISIT: www.mars-hydro.com www.marshydroled.ca PROMO CODE: rocknroll VISIT THE ALIEXPRESS STORE: @marshydro_aliexpress Instagram: @marshydropenny Thanks for taking the time to read and check out my diary🤜🤛 TS3000 FEATURES: WIDEBAND SUNLIGHT FULL SPECTRUM LED GROW, Infinite close to natural sun light, suit for all plants whole stages indoor growing, rapid plant response from seed to flower, achieve maximum quality and quantity, much better than traditional HPS grow systems. HIGH REFLECTIVE & NOISE FREE-Fanless LIGHT BOARDS design will make your growing life easy and quiet, quickly heat dispersing material aluminum reducing light lost to aisles and walls, increase the light intensity up to 20%, allowing your plants receive more energy and without burning your plants for maximum headroom. HIGH EFFICIENCY ENERGY SAVING PLANT LIGHT, high-power NEW LED grow, Compares to traditional 3000 watt HPS lamp and other brand led grow light while only 450 watts true output with 1016 LEDs, more scientifically and energy-efficient! Perfect for 5' x 5' veg stage, 4' x 4' bloom stage, higher intensity in a MARS HYDRO grow tent, reflective area, or by crossing over using multiple TS3000. BOOM YIELD LARGE GROW LIGHT, NEWEST SMD LED technology provide highest PAR/LUMEN output(1095.6umol/), makes you get 30% higher yield compare OLD led lights, can get max yield at 2.5g/watt, less pay but get more yield, bring a amazing grow trip to any home grower as it beams huge amounts of light energy to plants below. COMMERCIAL LED GROW LIGHT, Updated easy dimming & daisy chain function, main light controlled, especially come with two waterproof and dimmable Mean Well Drivers, auto sensing power supply works on both 120VAC and 240VAC and 277VAC, suit for Large Rooms and Commercial Setups. Low Energy-Consuming LED Grow Light: Consuming 300w and also mounted with 1016 chips, TS3000 has the ability to replace a 450w HPS light while reducing 40% power intake. High Efficiency LED Grow Light: With overall light output PPF 343umol/S as well as amazing PPE 2.3 umol/j, it's 50% even more photon efficient and can assure a 30% more return than the old HPS/MH lights. Patent Highly-Reflective Hood Shape: The reflector design on TS3000 is patented, which can effectively gather the light dispersed in all directions to enhance its light intensity as well as assist plants in absorbing more light. Full Spectrum Plants Favorite Spectra: By the unique mix of spectra that makes most light in the 400-700nm waveband, incredibly conducive to plant photosynthesis. Adequate IR(730-740nm) is additionally consisted of in the range to generate larger buds. Dimming And Daisy Chain Feature Available: Upon an independent dimming button on the external driver, backing 0-100% settings adaptation and up to 30 LEDs daisy-chained in a group, it supplies different light levels for various plant stages meanwhile saving energy. Safety Certifications And Service Warranty: CE, ETL, RoHS, UKCA security certifications accepted, 50,000 hours durability, 5-year service warranty, and local after-sales repair 5x5 GROW TENT: LOCK ALL LIGHT INSIDE MARS HYDRO Indoor Grow Tent interior is made of diamond mylar which is highly reflective. (Other brand's mylar and reflective rate is as low as 50%, won't provide efficient light. )MARS HYDRO 1680D canvas, being double stitched, it is tear proof and has perfect light locking. Mars Hydro's grow tent keeps 100% lighting beams inside and helps your plant absorb more lights. EXTRA-THICK --No light leaks or rips at all DURABILITY GROW TENT Stable metal corner adapters and poles are the trustful supporters of the tent, standing sturdy, neither rusting nor paint-falling, quick easy tool-free installation. Mars Hydro's heavy-duty metal zippers, with double layer black lining, are the best on the market which create a light-proof seal EASY OBSERVATION FOR YOUR PLANTS. Special observation windows are made by double layers of cloth. Observe the growing conditions of your plants without opening the tent and avoid disturbing plants. The observation window also serves to dissipate heat and ventilate air AUTOMATIC 6 INCH EXHAUST FAN KIT W/ CONTROLLER: Mars Hydro 6'' Inline Fan uses a mixed-flow design to maintain peak performance in a high static pressure environment. GROW TENT FAN: MARS HYDRO inline fans are designed to ventilate hydroponic grow rooms, transfer heating/cooling, cool AV closets, and exhaust odors. EFFECTIVE VENTILATION: Variable speed controller for easy fan speed adjustment. Optimal ventilation for your planting. LOW NOISE LEVEL: Durable plastic fan housing and blades for extremely low noise(32dB-A); create a truly quiet growth environment. EASY INSTALLATION: Removable duct ends with locking tabs for quick removal and easy maintenance and a cord length of 4.9 feet for hassle-free setup. This grows tent fan with a controller for easy fan speed adjustment. BASIC PARAMETERS: Ventilation exhaust fan size: 6” | Dimensions: 315mm*225mm*210mm. | Weight: 2.7. | Airflow: 402CFM | Noise: 32dB-A | Bearings: Dual Ball. 

Week two of flower is done and these girls are rocking hard .they have not slowed down stretching every day .feeding every 3 days 3 liters and they are loving it

Getting even closer now. Seeing some propr swelling and bulking on the bud sites now. Very strong smell coming from tent.

Crazy see the evaluation of my traits are kinda coming in slowly like my life steady & slow

Very nice plant to grow. Beautiful flowers covered with trichomes. The smell is very lemon citrus flavourt. She gave a bit of a stretch. I think she isn’t the biggest yielder but definitely quality over quantity. Later on the results. Very pleased sofar! I underestimate the density of the buds. Dry weight 375 gram of 5 plants. Pheno number 2 yielded almost 100 gram! Powerfull lemon flavour with a touch of sour. Running pheno number 2 again!

I am cutting G13 autoflower down today. She has run her course, and is ready to be harvested. She has a strong layer of resin with a woody, skunk, sweet, and fruity aroma. She grew well considering the issue I had early, especially after the mite treatments. We beat them, and she finished well. She will hang dry for 24 hours then get a mild wet trimming. From there She will go in the cannatrol for 8 days. Then I will final trim it, and do a smoke report. I want to thank Medic Grow, Athena, and Weed Seeds Express. 🤜🏻🤛🏻💪🏼❄️🌱 Thank you grow diaries community for the 👇likes👇, follows, comments, and subscriptions on my YouTube channel👇. ❄️🌱🍻 Happy Growing 🌱🌱🌱 https://youtube.com/channel/UCAhN7yRzWLpcaRHhMIQ7X4g