Week 9 their wasn’t any real changes. Everything is on par with week 8. Girl #1 looks like she’s starting to gain some more weight. I’m satisfied with her progression so far. Girl #2 still hasn’t shown any flowering. I will keep It short this week. Nothing really to report. I’m excited for the next coming weeks. Thank you for viewing my diary.

The plants have been flushing for almost a week now. Really starting to change colors. I can't wait to see how much I get from them.

Première signe que sa va moin bien… j’ai enlevé les feuilles atteinte de taches au maximum .j’ai attendu que le substrat soit bien sec et donner un dose d’engrais plus élevé. J’espère que ça va se reg

week 9 was a good week I watch my pollen sacks grow into beautiful pods cant wait to use it plant doing pretty good health and strong

все еще продолжаю гнуть и подготавливать будущий ковер из БЛЭКДЖЕКА!

Alles lief gut mit der Shaman bis zum jetzigen Zeitpunkt in der Blüte. Leider beginnt sich an einigen kleinen Stellen etwas Schimmel auszubilden, gar nicht in den Blüten, sondern an den Trieben. Das war mein eigener Fehler, da ich beim Entblättern einige Blätter letzte Woche nicht nach oben ziehend abgezwickt habe, sondern nach unten zur Erde hin gerichtet abgerissen habe. Dadurch habe ich an einigen Stellen das Gewebe am Trieb verletzt, wodurch sich dort Schimmel bilden kann und tut. Ich hoffe es wird sich in Grenzen halten. Es ist jedoch möglich, dass ich durch diesen Fehler zumindest einen der Haupttriebe verlieren kann. Wieder was gelernt. Gibt es irgendwelche Mittel, den Schimmel an den Trieben zu entfernen?Ansonsten bildet sie weiter ihre Buds aus, riecht schon sehr angenehm und entwickelt sich weiter. Es gab ein paar starke Winde und Böen in dieser Woche, dehalb wurde die Shaman vorsichtshalber gegen die Windrichtung angebunden, damit der Topf nicht kippt. Vielen Dank für euren Besuch und passt bei der Entlaubung auf...😫--- Everything was going well with the Shaman until now during flowering. Unfortunately, some mold is starting to form in a few small areas, not on the flowers themselves, but on the shoots. This was my own fault, as I didn't pull some leaves upwards when defoliating last week, but tore them off downwards towards the ground. This damaged the tissue on the shoot in some places, allowing mold to form and grow there. I hope it will be limited. However, it is possible that I may lose at least one of the main shoots as a result of this mistake. Another lesson learned. Is there any way to remove the mold from the shoots? Otherwise, it continues to form buds, smells very pleasant, and continues to develop. There were a few strong winds and gusts this week, so as a precaution, the Shaman was tied against the wind direction to prevent the pot from tipping over. Thank you very much for visiting, and be careful when defoliating...😫

She is officially on the 6th week now and here was how week 5 went! It was the most dramatic week so far, really started to fill out now and even the popcorn buds and starting to get some weight too. Now it’s just waiting for her to finish swelling then hopefully we will see her nearly ripened by end of next week! Smells fab! I can understand where the cookie idea comes from, my room smells like I have a warm batch of a variety of biscuits and cookies fresh out the oven cooling off!

I'm so excited! This week she entered flowering! Almost doubled her height! Grew 22cm this week! I have transplanted her into a 10 Litre fabric pot. I've never used these before, but they look promising. Different to airpots. I'd say more extreme tbh. Oxygen to the root zone is never a bad thing 😎

Stretching a lot at the moment, strong smell for only 2 weeks in flower. Pistils are now visible. As buds start to form. I moved the centre plant out as it was shorter than the others so looks a little more roomy now.

🚀 4 clones de Blueberry Pie F1 Fast seleccionados por @stacksfarmsltd - https://www.instagram.com/stacksfarmsltd 🚀 Breeding by @seedsmangenetics - https://www.seedsman.com/eu-en/blueberry-pie-f1-fast-feminised-seeds-sman-blpi-fast-fem 💦 BioTabs 15% DISCOUNT code "GDBT420" biotabs.nl/en/shop/ @biotabs_official 🌱Substrate PRO-MIX HP BACILLUS + MYCORRHIZAE @promixmitch @promixgrowers_unfiltered 💡2 x Mars Hydro FC1500 EVO Led Grow Light (2024 NEW FC 1500-EVO Samsung LM301H 150W LED) - https://marshydro.eu/products/fc1500-evo-led-grow-lights/ - https://www.amazon.de/dp/B0CSSGN5D8?ref=myi_title_dp

Start of week 2 flowering:) loving the structure like a little Bush! Moved her into the back under 1 3500 autocob :) all smiles people really happy the way she's coming along ! Ladybugs were introduced to help with my thrips issue huge differences :) Some updated shots !! Almost start of week 3 of flowering !

First time grower - Day 3 - Seedling Stage Unknown strain, hopefully its a female Light meter currently reads 101 lux x100 Should I give it more lighting or put it closer to the plant? Using roots organic soil, should I prepare for nutrient feeding after week 1? And if yes, what nutrients should I feed them?

After weeks of limp stem and no roots she has finally shown great progress. Fans leaves are expanding and her stem in hella strong

Sorry been away for so long. Been super busy at home and at work. Had turned my favorite pheno of the zkittz berry ade and turned into mother

the week passed splendidly, the bushes began to bloom and the smell was crackling the plants develop very well, I continue to water them with clean water and do not use chemicals. I removed the large leaves that were inside, on the sides I left now the light penetrates better in the middle

July 9: added Power Bloom and a handful of malted barley as a top dressing.

Défoliation

Finally the plant sprout, i'm Happy because the temperature this day gro wrong bit 11 seeds in the earth, 11 seeds sprout, fastbud Is fantastic😍 Edit: i posted others photos , i Hope Is brillant