It has recovered from all that stress and thriving again last spurt of tiny pistils exploding telling me it is still alive

Decided to LST in the end was a bit scared after the state of my Zkittlez OG, but decided to take some advice from a fellow grower here on GD hope all grows well and HAPPY GROWING GEEZERS!! 🙏🙏🤞🤞🌳🎄

The buds are very tight, but they didn't grow large colas so that means wasted time trimming cannabis, which I am not a huge fan of. I will not be growing this strain again, as I believe there are far better breeders and strains out there. I will continue to seek out the best breeders and strains until I am satisfied. I believe this Auto will yield in the 16-22 Ounce range dry, so I am not super disappointed, but I know I can do much better than this. After 6 days of drying, it took me around 7 hours to trim this auto, and she ended up yielding 16.72 Ounces. So she was definitely on the lower end of the spectrum from what I estimated on chop day, but still in the range. The buds are very tight, and smell like like cheese. I am only running one mature auto at a time now, so next up will be the Acid Dough from Ripper Seeds. I hope everyone has a great rest of your weekend, stay safe and Blaze On!!

2/5 Week 6 May be last week of veg kind of depends on factors outside the grow. Lets hope Keeping the Si included and leaving nuets as is. Continuing to defoliate as needed to keep things civil in the small tent, Moya is crowded. Canopy is at 30" plants about 20" 2/6 Better plan! Found a table at Goodwill that will fit in the flower tent and allow two plants to be moved there tomorrow. So tomorrow is the day, two plants will remain in Moya, prob Jool and Zhaan 2/7 Aeryn is in flower tent flipped to 12-12 Jool and Zhaan in small tent, Moya, also flipped to 12-12 Here we go Feed set as above, keeping levels low at this point 2/8 Second day May reduce feed a bit, white tips One time feed of Kangaroots 10ml/gal Keeping things defoliated so the middle gets lots of light 2/8 Last attempt to try and get rid of those white tips. Further reduced feed but added just a touch of cal-mag to make up for it. If this doesnt work I am just feeding them and ignoring the tips. Flowering is starting to show, more on Aeryn being under the HPS than Jool and Zhaan under the LEDs. Continuing to defoliate as needed to keep bud sites in light. 2/10 Bringing down the nuets to under 500ppm did the trick on the white tips but can not leave things there so back to some sane level and I am just going to ignore it. Stretch is starting for real 😳 2/11 Since the tip burning is an issue with N, I am going to move the girls to all bloom tomorrow with today as a transition. Strain is absolutely sensitive to Nitrogen.

d87 No se ha regado todavía, ha crecido bastante, muy ramificada, esta semana ha pegado un buen estirón, el cambio de luna nueva a luna llena les hace subir la savia a las hojas, ahora esta en cuarto creciente, se prevé buen crecimiento para la próxima semana. d90 Se ha regado con abundante agua y luego con 2L de mezcla con fertilizantes.

Chopped her two days into week 14. What else. Buds. There are a lot of them. And they are quite large. And they look like they will require little effort to trim. What more can I wish for? I am a very happy man. Upd 1: Trimming is SO SIMPLE! Not much sticking out to begin with, because of the amazing bud structure and me plucking most bud node fans. Solid nugs which are not bothered by anything, so pulling smaller sub-bud fans is very simple too, while the buds are what I would call moist. I'll call this Moist Trim 😄 ✂️✂️✂️ Went for the best trimming tools available on the market (well at least my research concluded so) and LOVING every minute of trimming with the B-500SRF. Why would I or anyone else use something less suitable or less comfortable for such a delicate and long job is beyond me, except if you cannot afford one right now, in which case I wish you to experience it one day. Fiskars are also very good in therms of the blades, coating and cutting ability and precision, but the spring is just too stiff, like way, way to stiff for something that is to be used for hours on end. One might argue that such spring force helps overcome resin buildup, but please just rinse your instrument regularly in an appropriate solvent (ethy, iso, whatever — consider you instrument materials as well) and wipe it after. Why would you let significant amounts of resin to accumulate on such a gentle and precise tool? Kinda defeats the purpose?

Discount code NINJABUDS: Air cube GROwACE.com Discount code NINJABUdS: ELUfAH Everything looks healthy for now. Nothing big to update yet I have not chosen which 6 plants I’m going to keep yet. I’m only going to keep one plant of each strain

Well after splitting the Girls up due to space it’s looking like the HPS Ladies are almost ready looking we’ll ahead of LED ones also buds are fatter with HPS but would say the LED ones look healthier looking if that makes sense

Start Woche 6: Jetzt wird final “gesetzt”. Nach dem strukturierten Aufbau in Woche 5 liegt der Fokus diese Woche darauf, die Pflanzen in eine stabile, performante Endform zu bringen: gleichmäßiges Canopy, saubere Lichtverteilung und eine Rootzone, die das Topfvolumen aktiv nutzt. Ziel ist, dass jede Top-Zone unter vergleichbaren Bedingungen arbeitet – das ist die Grundlage für eine effiziente nächste Phase. 🌿✅ Canopy / Training • Feintuning statt Stress: LST wird nur noch gezielt nachjustiert, um Tops auf eine Ebene zu bringen und Schattenzonen zu minimieren. • Struktur sichern: Triebe werden so geführt, dass Luftfluss im Inneren bleibt und keine überlappenden Blattpakete entstehen. • Priorität: gleichmäßige Spitzenhöhe + klare Triebführung → maximale Nutzfläche unter der Lampe. Klima & Licht (Wachstum pushen, ohne zu überfahren) Woche 6 entscheidet oft, wie “smooth” der Übergang später läuft. Daher: • Klima stabil halten, sodass Transpiration sauber läuft (keine kalten Bremsen, kein stehender Dampf). • Licht/Abstand so einstellen, dass die Pflanzen aktiv wachsen, aber ohne unnötigen Stress (Leaf-Pray, keine aufrollenden Kanten). Bewässerung / Rootzone Mit 7-L Pots ist jetzt wichtig, dass die Rootzone konstant arbeitet: • Rhythmus beibehalten, nicht hin- und herspringen. • Ziel: gleichmäßig feucht + maximaler Sauerstoff → aktive Wurzelspitzen = schnellerer Zuwachs. • Wenn der Topf schneller leicht wird, ist das ein gutes Zeichen: mehr Wurzelmasse, höherer Verbrauch. Plan für diese Woche Diese Woche wird die Form final fixiert: Canopy glätten, Mikroklima verbessern, Rootzone stabil halten. Wenn alles sauber läuft, ist das die perfekte Ausgangslage, um die Pflanzen kontrolliert in die nächste Phase zu führen. 🔥🏆

Día 44 (15/07) Wow! No hay shock de trasplante! 😍💥😁 Todas las ramas se han estirado hacia arriba tras el ajuste de LST y se están formando nuevos nodos rápidamente Esta combinación de nutrientes de Lurpe + substrato de PRO-MIX HP es una maravilla 😍 Día 45 (16/07) Ayer tuvimos ola de calor (37 ºC) y han aguantado muy bien! A última hora de la tarde (cuando ya no había sol directo) les apliqué H2O en spray foliarmente para refrescar los estomas Hoy parece que vuelven las temperaturas estándar para esta época del año: 29 - 30 ºC en las horas centrales del día Riego con 1 litro de H20 pH 6,5 Día 46 (17/07) Pequeños ajustes de LST Hay algunas ramas inferiores que no se han formado / estirado mucho Lo más probable es que haga una buena limpieza este domingo, 7 días después del trasplante, para dejar solo los brotes por encima del 4º nudo Día 47 (18/07) Riego con 0,5 litro de H20 pH 6,5 Este domingo (día 50) haré limpieza de partes bajas y tal vez también de nuevo topping en las 4-6 ramas principales 😁 Día 48 (19/07) Día de muchísimo calor con 37 ºC. A ver como lo llevan! Riego con 0,5 litro de H20 pH 6,5 Día 49 (20/07) Para ayudarles a llevar mejor el calor de las horas centrales del día, coloca una malla de sombreo (70%) sobre el invernadero Lo cierto es que se nota que baja mucho la temperatura debajo de la malla! Van a estar más fresquitas! 😍 Riego con 0,5 litro de H20 pH 6,5 Día 50 (21/07) Training session! Hago limpieza del tercio inferior de la planta, de todas las ramas y nudos que no superan la línea del dosel marcada por el 4º nudo (1er topping) También hago topping (2º) a todas las ramas principales La idea es tener 12 ó 14 colas principales para que no se hagan muy altas De paso saco unos cuantos clones de las ramas inferiores eliminadas 😁💥 Para superar el estrés, hago las siguientes aplicaciones y riego: - Riego con 1 Litro de Té Vegetativo de Lurpe Solutions. Preparación: 24 horas con bomba de aire (oxigenación) con ingredientes: Green Sunrise 8 ml/L + Insect Frass 16 ml/L + Hummus Lombriz 8 ml/L + Melaza 1 ml/L + Kelp Hidrolizado 0,25 g/L - Aplicación foliar Kelp hidrolizado de Lurpe Solutions a 0,25 ml/l 💦Nutrients by Lurpe Solutions - www.lurpenaturalsolutions.com 🌱Substrate PRO-MIX HP BACILLUS + MYCORRHIZAE - www.pthorticulture.com/en/products/pro-mix-hp-biostimulant-plus-mycorrhizae

🌱Day 58. Constantly keep watering with plain ph balanced water. Zero nutrients. Super soil working well.💚 🌱Day 60.💚 🌱Day 62.💚

Flowering week three

Trichomes are plenty but crystal clear. The buds in the center cola are tight and dense. It is smelly as ever. Patiently waiting.

Week 7 Flower - Notice that the tops of some of the Tops are pretty hard. Think they got a bit cooked by the LED... Hifi 4G & Blueberry Pics are missing from this week...I thought I had taken some footage, but seems that I got distracted. Work has been nuts so not surprising that I gapped on that. Hifi 4G is needed more support. Looks like a blue ribbon chaos around it. Blueberry looks fantastic.

The flushing phase is on, time to get rid of the rest of those nutrients that got locked up in the plant system, this step will affect almost 60% of the end result bud quality and taste along side with curing and drying properly the buds. The plant will remains in darkness until i harvest to slow the degradation of thc to cbn and to squeeze the most out of thoses resin glands that activates the most at night . Beside a bit of foxtailing due to the heat differences caused by the addition of 3 cfl buld, the buds are looking great

Selbes Bedingungen wie bei der strawlectric lemonade. Ging aber 11 Tage bis sie trocken war.

Top her again Waiting for to recover from another round of topping Check out my Cannabis Community, please👇like👇, follow, comment, and subscribe to my YouTube channel👇. ❄️🌱🍻 https://www.youtube.com/@DutchF4rmer Join our cannabis community community for weekly giveaways 👌 (Discord Server) https://discord.gg/VMu6rH4a7V It will be appreciated! ❤️ Happy Growing 🌱🌱🌱

Zusammenschnitt letzte Runde Ernte

Ja wie auch bei der runtz, die zuckerblätter sind stark trichomen besetzt. Und hier hatte ich beim lollipoppen wie erwartet etwas mehr Arbeit. Ebenfalls habe ich hier ein paar kleinere untere doch kräftigen bads wegschneiden müssen. Da das Licht reinbringen, durch Sägeblätter entfernen super funktioniert hat, brauche dich auch gefühlt unten sehr rum sehr wenig wegnehmen. Mittlerweile hat man vom Geruch her eine doch würzige dumpfe Note die am Ende doch leicht fruchtig ausläuft. Ich bin weiterhin gespannt wie am Ende die was aussehen und wieder Geschmack sein wird. Und der Vergleich unter den beiden Pflanzen und Sorten ist sehr interessant und sehr schön im Video sichtbar. Auch hier haben die buds richtig viel Potenzial schön dick zu werden. Aber vom Gefühl her bis zum jetzigen drücken muss ich sagen, die werden minimal luftiger werden als die von der runtz.