Hallo zusammen 🤙. Sie wächst sehr schön und macht keine Umstände.

-Loading-

11/17 Week 10 Ripley - Starting her on the Soul Peak very soon, low dose 5ml see how she takes it will reduce CocoTek on just her by 3ml/gal at that dose. Keep defoliating her gently, dozen of so leaves every day or so just to keep buds open to light. No visible problems Tara - The Beast - Ok now it officially the largest plant we have grown to date. With the pot its hitting 4 ft 8 in without 3 ft 2 in. The stretch has finally slowed to a stop and buds are beginning to quickly build... thank you God. I was really wondering what I was going to do next. Am going to have to bind her up a bit just for support tomorrow as those buds get heavy and she needs to give Ripley some room. Also cleaning the heck out of the lower end tomorrow. Keeping her CocoTek at current level with a Cal-Mag foliar every few days 1/19 Foliar Cal-Mag feed on Tara Cleaned out the bottom of Tara, first pass at least see how it turns out. Decided to put Tara on the same feed as Ripley see what happens as Ripley is building buds faster with the PK cant say that would hurt Tara, No def so may as well May be early but heck what do I know, on new ground here 1/20 So far so good, cleaned up Tara a bit and bound her up to give support and room for Ripley. Buds building nicely crap load of them Ripley doing well in the pK so will continue her protocol by slowly reducing CT and inc PK 1/21 Noticing some mag def on Tara and random Ca spots so getting a dose of Cal-Mag 3ml/gal as well as the foliar. 1/22 3ml/gal CalMag added to Tara feed reduced CT 2ml/gal Ripley on 5ml/gal CocoTek AB and 10ml/gal Peak getting her ready for flush 1/23 Going to try alternating between adding 3ml Cal-Mag to Tara's feed and foliar with same. Not a bad Mg problem but obviously one I cant ignore given its Ca as well. Ripley on 6.1 Water and 15ml/gal Peak one more day then flushing to start week 11

I’m flipping 12/12 this evening. I had a little tip burn on a couple of leaves of the Fullgas. These were in the central area of the light so I just eased off a little on the light intensity and haven’t noticed any issue since. It’s also a little dark atm so will hold off adding the bio grow until next week. Update ** Ive upped the light power by 10% again and watered in 4ml of Alg a mic in 2L of water.

Ya casi por finalizar 😃 estoy muy emocionado por el resultado final, todo pinta bien 👌🏻💯 se puede mejorar aún más pero estoy conforme con el resultado de esta planta 🌱 Esta semana fui bajando la ec poco a poco hasta llegar a pura agua, la semana que viene será de puro flush 🚿 ya para cosechar 🤩

Legend Timestamp: 📅 Measures: 🛠️ Water: 🌊 Actions: 💼 Thoughts: 🧠 Events: 🚀 ________________________________ 📅 D50/F11 - 12/10/23 🛠️ EC 1.3 (stable) pH 5.5 (raised) -- pure water 🌊 RES Changed 💦💦💦 💼 Made some LST on the little one. No more work on the bigger 🧠 I'm going to change the water within today and run it for 12-24h and then put only bloom nutes 🚀 ________________________________ 📅 D51/F12 - 13/10/23 🛠️ EC 1.3 (by set up) pH 5.5 🌊 New water, calmag, bloom A and B and B52 💼 Removed all LST constraints on the big one. Some spouts removed from the little one. Some defolation 🧠 All training was removed now I will let her grow normally 🚀 ________________________________ 📅 D52/F13 - 14/10/23 🛠️ EC 1.0 (falling) pH 6 (rising) -- EC 1.3 pH 6.1 🌊 No water added. Added Big Bud and Bud candy to raise EC until 1.3 💼 LST and defolation on the little one. Made Timelapse video. 🧠 She's eating a lot: very good 🚀 The little one is sprouting out the first petals ________________________________ 📅 D53/F14 - 15/10/23 🛠️ EC 1.1 (falling) pH 5.2 (falling) -- EC 1.45 pH 5.4 🌊 Water decresed a lot. Added 4L and Bloom A-B - Calmag and a little of Rhino Skin (silica) 💼 LST on the little one, some defolation on the big 🧠 I would like to have only nice big fat buds, so I need to work on this goal 🚀 ________________________________ 📅 D54/F15 - 16/10/23 🛠️ EC 1.5 (rising) pH 4.7 (falling) -- EC 1.4 pH 5.4 🌊 Water decresed a lot. Added 6L Bloom A-B and lot of Calmag 💼 Only a little defolation 🧠 Next time, no calmag at all 🚀 By mistake I added a lot of calmag so to balance I have to add lot of water and now the pot is completly full. Keep in mind there is a lot of Calmag in it ________________________________ 📅 D55/F16 - 17/10/23 🛠️ EC 1.5 (stable) pH 5.2 (rising) -- EC 1.2 pH 5.4 🌊 Added pure water and a little of silica (Rhino skin) 💼 🧠 🚀 Some leafes tips are burning, so I'm going to go back to 1,2, trying to have a good pH range ________________________________ 📅 D56/F17 - 18/10/23 🛠️ EC 1.2 (stable) pH 5.7 (rising) 🌊 No water neither nutes added 💼 Little defolation 🧠 Maybe the Thrips from Granada come out and infected Marlene. I will spray also her tonigh 🚀 Some symptoms of insects like leaves bitten

New experiment stay tuned. Found this old pot may be 40-60 gallons im not sure the thing is huge. I had to squeeze it in the closet.

This week some of the plants are starting to show a few brown pistils on the calyxes as an indicator that peak bloom period is occurring. I don’t expect them to do much other than fill out a bit at this point with exception of some of the more Sativa phenotypes like the Tangerine Dream. One of the these seedplants failed to bloom properly it may lack the autoflowering genes. I don't want to risk damaging the roots in the system by culling it. I might leave it in to see what happens and transplant it before I clean out the system for the fall grow. I’m pretty satisfied with the autoflower grow so far but I do have some room for improvement: 1) Next grow I will use CNS17 Ripe possibly from start to finish to see if that improves the flowering of the plants. I feel that my feed is high in nitrates so I am starting to flush this week. 2) You can see by the plants all showed variation in physical appearance and Trichrome production. The only plant that has gone purple out of the batch and is a high yielding Gorilla Zittles from Barneys. If I grow autoflowers again in this system I want to choose plants that are a little more uniform. I think the Botanicare Turbo Garden and similar systems are best suited for clones as they grow a little more uniform. Autoflowers even from the same strain have a wide variation which is cool because every seed is a surprise. 3) I need an overhead plant support. I am not sure how the plants survived some pretty high winds. One stem broke and I repaired it enough so that the plant actually survived. 4) I'm working on a microcontroller sensor node to allow some automation to the system. My favorite plants in this batch are the Dinafem Amnesia Auto CBD based only on aesthetics at this point. The Blue Dream Auto from Humbolt is one of the smaller plants but it has quite a bit of resin on it. The smaller plants may have been stunted as my nute level from the beginning was approaching upper limits for leaf burn (1.7-1.8 EC). I had since backed down but over-fertilization in early stages is not reversible and comes at a cost of plant health and vigor. I took a video to try and show the overall garden progress. I did not defoliate this grow which makes it hard to see the individual flower structure but I will have defoliated harvest photos coming up soon!

Mykorrhizza zum umtopfen per Augenmaß direkt auf die Wurzeln gestreut.

hi guys, although the plant was born at the end of summer it is growing well and fast, the vegetative growth lasted about 4 weeks

Took some nice pictures with my microscope at the begin of this week from a underdeveloped budrot bud. So the other buds might have more and better thc on it. This is the end of the 6th week of flowering. Gave the plants only enzymen, because I don't know how long I can keep them going on flowering with this climate. Therefore I rather not feed them( there are still alot of nutrients in the soil), so they are not full of nutrients when I have to suddenly harvest them. As you can see, they take the nutrients out of the leafs as well, because they don't get nutrients from my watering. Might give them some Humic-Blast as well, in the new week. Will harvest them in 1 or 2 weeks depending on climate + growth of buds. The front plant buds didn't swell that much but the plant behind keeps flowering, not much but bit by bit. It's understandable because the day temperature is between 10-20 degrees fahrenheit and night temp is between 5-12 LOL

Pilot — Week 5 Flowering Pilot is progressing through week 5 with excellent flower stacking and increasing resin production. Buds are swelling along every branch, while the open plant structure continues to promote uniform light distribution and airflow. The flowers are becoming denser each day, with abundant white pistils and a clear increase in terpene expression. The plant maintains a healthy balance between vigor and flower production, showing strong potential for a heavy, resin-rich finish during the final weeks of flowering. Seeds by World Breeders Cultivated by Piperoots 🇲🇦 🌱🔥

Week 5 flowering Now the swelling begins

1000ppfd

The two northern lights auto are dry. Together 45g before drytrim. Not too bad, concidering the cloudy, wet weather..

My Purple Kush plant is still the smallest in the tent, but hopefully it'll produce some good buds by the end. It's been a challenging week with the constant rain and ridiculously high humidity. Keeping things dry indoors has been a real struggle. Despite the weather, I managed to flip all my feminized photoperiod plants to flower this week. I'm hoping the switch will go smoothly, but with this humidity, it's going to be tough.

Settima settimana di fiori

Day 63 - haha.... mazar are lookin pretty good... one of the ssh was male, so one of the mazar got moved into a big 19lt, IWS DWC Oxipot .......... lol just kept it in the same established plastic top/basket, and just put it straight into the top of dwc pot.... fits ok, so there's no disruption to the roots..... 👍 fans arrived, 20w :) just slowly moving along nicely.... not in any rush ... so just let em keep veggin... might top em, or something... try to get their stalks alot stronger.... Day 66 - 2 vids... topped em, lookin good ... 👍😎