H2O Algas Enzimas

Dear diary, Week 2 done and on the books! Everything went mostly fine up until the very end of the week were I noticed some strangeness with G.C #2 that was transplanted. That will be covered more overall in next weeks update as I try to fix any potential issues. 🍀🍀🍀🍀🍀🍀🍀🍀🍀🍀 ⏰ Day 11: Calmag foliar applied 2 times during the day at 0.8ms and corrected ph to 6.3. They also got their regular feeding at 1.27ms 6.4ph with me increasing the light to 250ppfd. ⏰ Day 12: They were given a foliar and watering of calmag water at 1.13ms and 6.3ph early in the morning as issues had not cleared up. Later in the evening they got a regular feeding at 1.41ms, 5.9ph and lights were increased to 275ppfd. ⏰ Day 13: 2 calmag foliars, gave feeding at 1.54ms 5.8ph and increased lights to 285ppfd ⏰ Day 14: They have reached 3 nodes marking the end of seedling stage and beginning of veg! They were fed with 1.53ms 5.8ph and four 3 liter airpots was prepped with 75/25 coco/perlite and watered with the same feed until runoff before transplanting. As I can only grow four plants G.C #2 and #3 were selected as the final two. Temps are around 26 and RH 75% with lights on and 24C 80% off. Will be taking down the RH slightly over the coming few days to 65%. ⏰ Day 15: Gave the girls a feeding at 1.57ms 5.6ph. Also increased light to 305ppfd and they do look a bit droopy, but that’s not to surprising after the transplant. ⏰ Day 16: Daily feeding at 6ph 1.59ms and increased light to 320 ppfd. Aiming for 465 ppfd by the end of next week as that would move us up from 20 to 30 DLI. ⏰ Day 17: Sprayed a foliar coat of Leaf Coat from Biobizz as prevention for pest in the morning. For the evening they got their feeding at 1.58ms 6.2ph and foliar spray of calmag as G.C #2 is showing some strangness like small white marks and drooping on the new leaves. Will troubleshoot and give her a few days or so to see if she improves or else I will change in the plan-B G.C that wasn’t transplanted.

Very resilient strain with lots of vigour and excellent growth. Little to no training required. Two distinguishable Phenos, one stayed short and bushy with leaves resembling more Indica and the other had more stretch with more inter-nodal spacing showing her sativa side. Great hybrid would recommended to anyone who’s a fan of OG Kush with a twist.

NEW 200W LIGHT vry cool stuff, buds sticky and smell amazing

This week the girls were covered in snow. I've never seen anything like it with my own eyes before, only in pictures :D The lower large leaves have turned yellow, but this time don't panic :D experts say it's normal.

Läuft.........

- 1st Day flowering for Ak (5/9) - 1st Day flowering for Critical (8/9)

half way through the first week of flower and the stretch is in full effect. canopy is going to be completely full in a few days, scared for my dwarf white runtz in the middle of the group, itll get swallowed

🌱: 💧 : 10l, added 0,1ml/l PK13-14 on day 41 💡 : Dli: 45 mol/m²/d 🤔: Switch to Spider Farmer equipment on day 41

Venga familia, que actualizo la 8 semana de floración de estas Kritical. Ya se ven en la recta final , falta madurar un poco más, yo creo que con 10,14 días estarían ya apañadas pero decir es aproximar. Ya se realizó el lavado de raíces, y aparte llevan una semana ya solo con agua. La verdad que hasta aquí estoy contento con el resultado hasta ahora. Agrobeta: https://www.agrobeta.com/agrobetatiendaonline/36-abonos-canamo Mars hydro: Code discount: EL420 https://www.mars-hydro.com/ Las maximas de temperatura no superan los 26 grados y las mínimas no bajan 20, así que no me puedo quejar. Los niveles de humedad también son los correctos van entre 45%/55% de humedad relativa. Por supuesto el Ph lo estamos dejando alrededor de 6. Hasta aquí es todo, buenos humos 💨💨💨.

The nematodes worked great against the fungus gnats and i almost completely got rid of them. Starting to feed her this week. Also started with low stress training this week.

Been a little busy lately however these girls are going strong.

Already week 7, and it’s starting with much better air humidity which makes it easier for me to stay in the recommended VPD range – currently 54% at 25 °C at canopy height. With 58, 67, 78 and 80 cm plants’ average height is about 71 cm. Odour has increased, and sometimes, but only shortly, I get the feeling the coal before the blowers cannot eliminate all of it. While the smell was a bit strange sometimes one and a half week ago, it’s now absolutely yummy, sweet and promising. As is all the sticky stuff adhering to my folding rule when I measure their size. I am a bit confused about the amount of yellowing leaves. That would indicate a nutrition deficit. On the other hand, last feeding (yesterday it was only calmagged water) brought some brown edges to their tips as I wrote. Which could indicate a slight over-nutrition. I am not *that* worried as leaves around the buds all look great (except for mentioned, but not youngest tips), and mature plants obviously tend to concentrate on bud production solely. But week 7 is quite early, or isn’t it? Any recommendations? Maybe I should go with organic fertiliser next time to avoid being stuck between two options ;) As they had run dry already, I gave each one another round of drink. Slightly less fertilised than last week. And I removed the lowest yellow branches and tiny buds that would not make it into the light in time. The Pineapples must have some mimosa genes crossed in. Each time I touch them they bow away their heads in deep dislike. The taller one looks like her head would be too heavy now … It is not, and usually they recover after an hour or so. The Sherbets are pretty unimpressed by all I do. Meanwhile I’ve been working on the Raspberry Pi BoxControl that should help me stay in better VPD ranges in the future. I am not sure how to translate this all into a more stable solution than based on a breadboard, but the state so far (and how it is supposed to work): Raspi runs headless with control software on autostart. Every minute temperature and humidity are received from a GY-21 I2C chip that should be hanging around plant tops. Data is saved in a database, VPD is calculated and signalled in form of a RGB LED color. Additionally, LCD display rotates through current stats. 3 relay modules can en- or disable misting, dehydration or an additional blower. Maybe I can add a CO2 sensor just for the fun of it (but I’d have to develop a device protocol myself), maybe even one or two soil moisture sensors. Theoretically you could also have a lighting control, but then, GPIO ports are all used. The display needs a lot of them, and while I can log onto the Raspi on my local network and view its desktop, I’d prefer to have a quick overview at place. I am not really informed about current models. Are some GPIO extensions or Raspis with extended GPIOs on the market? But so far, that’s all theory. I never had a PCB developed for my hobbyist projects, I am not the best with a solder station. Never had a Raspi run 24/7 for a really long time. Did a bit more lollipop ping in the evening. Especially tallest Shepard had fun building some more very low buds and branches. I think it can investigate its powers better on different places. Day 51: It’s getting hard to measure soil humidity with my low tech device. Soil must be full with roots and I don’t want to hurt them much. I can see them at the outlets of their pots too, sometimes a bit dry of course as these parts run dry earliest. Experiments to include the CO2 sensor in my test setup failed. I can read and reset it, but setting measurement mode and reading values don’t work. Maybe because my I2C library cannot use ClockStretchLimit. Running out of GPIO ports anyway and seeing that the soil sensors are analogue devices, I’ll probably revive my Uno too and have discovered some clever Raspi heads that should make a more stable setup (and some cooling) possible while also adding a handful of PWM ports and an integrated display. I’d like to include a camera module too and it would be great to have some ports available. A final setup would obviously include a Raspi 4 or 5 to easily enable secure online access. But so far, all working nicely in test setup. Day 54: Sometimes I wonder if they’re still growing at all, but then it’s good to have the daily pictures to compare bud width which now seems to be the main interest of the ladies, although differences are now clearer to tell between two day intervals. The taller ones look like they are one week ahead of the smaller plants, with even higher fan leaves turning pale now. Which at an estimated seed–harvest time of 8–11 weeks for both strains should be pretty common, I guess. Or am I wrong? Summerly temperatures make the temperatures at canopy level sometimes reach 31 °C, but at least the simple ultrasonic diffusers arrived and I am getting closer to a better environment control. I can at least switch the diffuser inside the tent remotely from my phone, and a deep bowl of water with a lid so the "fountain" produced will not wet the tent floor and one of the fans placed at the bottom now to lift its mist upwards seems to do the trick. Humidity increases while temperature drops, getting the plants into a better VPD level, so all I have to do is wait for the evil A to deliver the necessary Raspi components to have this automated, maybe still while this grow runs. At the end of this week, there was just a bit of height gain for the two smaller ladies who now approach their next 10 cm mark. Overall, I get the feeling it won’t be that long until harvest. Maybe with the taller ones a week earlier than the others. There’s really not that much bud growth anymore, rather refinements – like buds getting more nodes and color. I’ll investigate the trichomes every few days but would welcome your estimation.

Increased Buddy to 1mm p/l. Really impressed with these nutrients so far, there's been no problems or defeciences the entire grow. All plants look happy, healthy and green. This plant is at the back of the timelapses.

This plant has been very enjoyable to grow and the smell of it is incredibly Pleasant I will update when the plants are drying and ready for curing it will take approximately between 7 and 14 days because I wait until the main stem snaps with a crunchy sound. Day 5 of drying and they are still far away from ready but they're starting to show a nice Colours now . the smell it's becoming very powerful even without curing I know many Growers cut them down when the smaller branch are snapping off easy but I wait until the main stem I bend and a crunch very dry sound come out of it because I don't like to deal with mold and I have a very busy life can be opening curing jars every few hours everyday that's why a good Boveda packs and a good drying are my best friends. These are the weights for the two plants that one that was bigger #1 is 51.12 grams the second plant #2 was 36.17 grams . They smell very nice like a kiwi skunk smell to it . The high are strong and last about hour and a half to two hours. For a regular smoker I will classified as day stuff on the Stoney side. With a high THC probably what is advertised on their website . This is very good for somebody who wants to have a quick grow of very good stuff or somebody who lacks space but doesn't want to sacrifice quality. The fact that I couldn't get a large yield out of it was a bomber for me I really like plants that are capable of producing a large yield. Taste 10 out of 10 Aroma 10 out of 10 High 8 out of 10 . day. strong THC. Yield 6 out of 10. Easy to grow strain. Possible to crop in 65 days from seed at 20h lights on.32 Centigrades and 45%humidity. Thank you for reading I will continue to update have a happy grow.

Info: Unfortunately, I had to find out that my account is used for fake pages in social media. I am only active here on growdiaries. I am not on facebook instagram twitter etc All accounts except this one are fake. Flowering day 11 since time change to 12/12 h. Hi everyone . The lady is developing beautifully :-). The buds start to grow . I added 2 g GHSC Bio Bloom per l coco. Otherwise everything was checked and cleaned as usual. Have fun with the update and stay healthy 🙏🏻 You can buy this Strain at : https://www.exoticseed.eu/ Type: Herz Og ☝️🏼 Genetics: Larry OG X Kosher Kush Indica 60 % / Sativa 40 % 👍 Vega lamp: 2 x Todogrow Led Quantum Board 100 W 💡 Bloom Lamp : 2 x Todogrow Led Cxb 3590 COB 3500 K 205W 💡💡☝️🏼 Soil : Canna Coco Professional + ☝️🏼 Fertilizer: Green House Powder Feeding ☝️🏼🌱 Water: Osmosis water mixed with normal water (24 hours stale that the chlorine evaporates) to 0.2 EC. Add Cal / Mag to 0.4 Ec Ph with Organic Ph - to 5.5 - 5.8 .

Well, it looks as if one of the 3 plants is a male. I live in denial for one more day and then I toss it. Not sure which plant it is, as I painted over the strain names when I painted the cups grey. Smooth. So I will find out soon. Otherwise, good weather and some good growth. Roots are balled up at the bottom of the dutch bucket reservoir, Im sure, because I let the drip go dry for a day or two and the plants were droopin (coco)