Likes
Comments
Share
@PapaNugs
Follow
These girls are super sticky! Resin is building up all over the place, including the leaves. I've been defoliating like crazy but they just keep coming back. These girl have a wide range of smells. Ranging from gas to mild strawberries. I'm hoping they get more strawberry as we finish.
Likes
65
Share
@Dendegrow
Follow
So the net is installed, lets wait until it is full covered and then going into bloom. I make this time a trial only to feed the Organe sherbet with Melass yeast buddermilk and sugar in vegetation. The yeast will produce the whole grow enough co2 to keep it up about 800 ppm only thing you have to do is to put some sugar in the feeding solution.
Likes
38
Share
@PapaNugs
Follow
SO, the girls were doing so well into their second week I decided to do the unthinkable... I topped autos! 😳😳🤯🤯 I figured they were doing so well and hadn't entered flower yet; let's do our best to keep them small and get multiple good buds instead of just one. This will also give me the best opportunity to lst them down using ties. Stayed tuned for that! This girl is doing the best out of them all still. She was the whole real I decided to top them. I'm looking forward to what she'll produce. Dimmed to 40% but increased it today to 60% Here are the lights details: Medic Grow Mini Sun-2 150W LED Model: MN150-022 Spectrum mode: V1 Efficacy: 2.8 umol/J Thanks for stopping by! You can find the light on Grow Diaries: https://growdiaries.com/grow-lights/medic-grow/mini-sun-2-150-watts You can find the light on Medic Grow's website: https://medicgrow.com/
Likes
3
Share
@Passx
Follow
Plant ready to be harvested in 1,5 - 2 weeks so I stopped feeding it with nutrients. The flowers got bigger and much more sticky. The smell became very strong.
Likes
14
Share
Day 36 Starting supercrop! Day 38 Second toppings!
Likes
15
Share
@Waveform
Follow
Waiting for first signs of life … While we are, I thought I’d give you a short explanation on the software’s graphics in case you did not follow my first diary. The one to the upper left, as its headline says, is the temperature graph. Most important line is the red one, showing the leaf temperature measured with an infrared temperature sensor. As there are no leaves yet, it is pointed towards one of the pot’s wall at soil level. Air temperature from a sensor that usually hangs around somewhere around top level is violet, and the grey line is the outside temperature close to the tent, helping the software to determine if a main blower action will effectively lower temperature. As I learned from the first grow a plant day that corresponds to the natural day can cause enormous gaps both to temperature and humidity, I inverted the plant day now, starting their night at 11 a.m. So after the first day temperature will only vary around 1.5 °C, which is of course due to the low light intensity too. Humidity graph on the upper right is quite crowded. Main line is the blue one, tent air humidity, which on this first day was between excellent 65 – 70% most of the time. For the moment humidifier is electrically disabled. There is quite some excess humidity on the tent floor and no reason to push this any further. Outside air humidity is grey again and taken from the same outside sensor that reports outside temperature. The soil humidity sensors are simple analogue capacitive sensors which have their flaws. I am interpolating their measurements to have a somewhat smoother reading, but as you can see from the turquoise humidifier reservoir reading (in legend named as plant soil hum 1), they can get confused when humidity is very high and start to report random numbers for some time. The most important graph for all growing stages is the lower left one, where the pink line meaning plant VPD should be inside the green optimum range for somewhat perfect conditions. This cannot be attained all of the time – dehumidifying isn’t as easy as humidifying –, but software tries its best to do so. Outside VPD is grey again. The last graph is more for amusement than anything else. The light intensity sensor is hard to position correctly, and everything you see about illumination and DLI (orange and green, plus grey for the accumulated 24 h DLI) should be taken with some spoonful of salt. Any resemblance to real world professional instrument readings can be considered purely coincidental. The violet line is the CO2 reading from such a sensor, and you can see that its tiny peaks correspond to even tinier black peaks at the bottom of the graph, reading TVOC values which in this case, once they will be more than possible measurement irregularities, can be interpreted as smell. ------- End of week 1: All seeds germinated. I wasn’t at home most of the time, and it turned out using the humidity sensor to monitor the humidifier’s tank wasn’t good for the stability of the system. Arduino crashed, so there are no pictures yet and no graphs to show. I have the feeling light was a bit low as the seedlings grew a bit tall, but with lights now up to 20% I guess this problem is fixed. More tomorrow when I have some more data to share. Even more end of week 1 (I extended this week to 9 days as I cannot tell when the seedlings started to show): Lights are at 40%, meaning 40 W in total. No reason to give them new water until next week. As some flies showed up from the BioBizz soil, I added 2 yellow cards. So far, everything in normal ranges. I’ll switch the control to grow phase soon which will raise the VPD slightly by 0.5 kPa. It’s interesting to see the CO2 level started to climb by 50% during their last night and has not come down to baseline afterwards. I restarted the app to check if the sensor had lost its calibration, but it still sits at around 660 ppm now.
Likes
34
Share
Неделя прошла вроде бы нормально, куст подходит к своей логической развязке, а точнее к харвесту по немногу и это очень и очень радует) Многие листья начинают уже сильно желтеть и отсыхать сами, хотя все условия хорошие) Шишки ещё некоторые надуваются, а многие затвердевают уже, собераюсь дождатся янтаря, по этому ещё затянется не плохо время(
Likes
Comments
Share
Likes
23
Share
Terza settimana e tt procedere come deve.la lascerò ancora qualche settimana e poi via tutte in fioritura 🌺🥀🍁
Likes
7
Share
Blüte Woche 3 vorbei und die Pflanzen sehen wunderbar aus, sehr vital
Likes
12
Share
@Froggman
Follow
Not giving her much water these days; today’s may have been here last. I think one more week, maybe two?
Likes
100
Share
Giorno 65 Ad oggi ho tagliato le due Rainbow Belts (qualche giorno prima per esaltarne il gusto Zkittlez) e le due Zombie Kush una al giorno 58 l'altra giorno 63. Rimane questa bestia di Milk Monkey. Sento biscotti sento vaniglia ma sento anche dell'acido. Mai avuto cime così piene di resina. Mamma mia che spettacolo di banca semi questa Exotic Genetics (meglio spendere qualche euro in più e avere erba che vale 20/25euro al grammo che spendere poco per avere erba commerciale) Saluti e a settimane prossima 🖐️ ❤️
Likes
2
Share
@Hash268
Follow
From seed to flower I've been impressed with the white fire gelato she's a great strain didn't take much to make her happy and she grew with such life like she was really happy I will agree on that because she smells and taste as great as she looks, the buds was heavy but she held on to them, very strong gelato aroma and taste, very sticky and she is not a big eater.
Likes
17
Share
Pandemic “Third Wave” hit. Looking forward to share my Next attempt. 🐈🐟🌱Aquaponic Grow🐟🌱🐈 #Germination 🗓️19 Jul 2021 Germination was simple. Just added some seeds in plant cups. Tank setup is as follow: Tank 40 liter Air Pump 2.5w SHANDA SD-900 Mini Aquarium Water Pump Small 2 Air Stone Grow medium mostly consist of small sea shells and rocks washed and packed. Fish: Gold Fish named Ed, Edd, Eddie After the wash of the grow media and Tank water fill I let the system run for a week. This allows the water condition to stabilize. Used spring water. The fish were placed in tank still in bag for water temp reasons. Opened the bang and kept the fish in tank for a week before planting seeds. Micro Bacteria to form in grow medium. Will be adding a Root Conditioner soon. Looking for on thats not harmful to the fish. 🌱New Posts Ever Monday🌱 Follow and like my instagram: https://www.instagram.com/p/CPRd1WeA4WP/?utm_medium=copy_link Thanks for Reading Joe & Pop-Corn🐈
Processing
Likes
2
Share
End week 9 Changed the nutrient solution and plucked a couple fan leaves along the way. They look happy and healthy and I'm letting them take over this 5x6 space I usually put 6 ladies in. Excited for the outcome of these plants.
Likes
11
Share
PHENO 2 WEEK 6 Money trees is the perfect place for shade, and that's jus' how I feel pineapple candy, zesty diesel terps
Likes
10
Share
Buenas gente! Esta semana se nota tremendamente el engorde de los calices, y algunos comienzan a cerrar de a poco! Una maravilla en cuanto a terpenos!! Tuve el honor de cortar unas flores para analizar en la expocannabis uruguay, les dejo un video con esa info de una de los 4 fenos. Empezamos a lavarr, primer uso del flawless asi que nos ponemos con el lavaditooo!! Venimos bien de bien. Saludos Jardin33ro 🇺🇾
Processing
Likes
8
Share
This was the last week of flowering and therefore I stopped giving any nutrients for a good FLUSH. This is very important in order to avoid a harsh smoke later when the plants are dried, because any nutrients left in the plant will burn your throat and the weed will hurt while you smoke it. Both Barbarian (=AK-47 x Barbara Bud) plants have developed well and carry hefty top buds on each side branch and also the main cola. The lower regions also carry buds, but those are a little more fluffy and not so big and dense as the top buds. Every bud is COVERED IN TRICHOMES and the plants glisten in the light, they are FROSTY AS HELL! The plants have a STRONG AROMA now, which is sweet and peachy with hints of sandalwood. They smell ABSOLUTELY DELICIOUS and I cant wait to try the dried end-product. All in all I can only recommend this strain, its not the biggest yielder, but definitely delivers connoisseur grade weed. Hats off to Mat from House of the Great Gardener in Canada, he has made another GREAT cross and I hope he will release this variety soon! 👍😍😎