Im feeding her steadily at around 825ppm every morning monitoring any possible deficiencies. I did defoliate quite a few leaves from the to[ and bottom once I felt that she is thriving happy and growing more vigorously during the stretch. I raised the light a full 2 feet. during week 1 and now at the end of week 2 the tallest stalk is about 14 inches while most are around 20. reason for a few stalks being taller is because of what happened when our 3rd plant ended up being a male during the transition to 12/12. Im not gna try anything crazy to try and fix it. Obviously there are no problems so dont fix whats not broken I guess. Have a great week !

This week was over 100 heat index for several days but the plants did not require any more water than normal. I feed with compost tea at 600 ppm at the begging of the week the night before the heatwave. Then again with cal-mag water 2 days later in the morning and they have been holding onto steady moisture for 3 days I wanted to hold off on watering because we have some rain in the forecast. I also topped of with a cup of BSF frass and quarter cup of neem seed meal before feeding the compost. Still not Mantis cocoon hatch! Sti have not got clones yet, s i have it cleaned the bottoms or defoliated yet as I want to use them.

My second hydro grow and it seems I failed a bit here: 1. Too little defoliation and airflow 2. More light to mid and lower branches. Low light and low airflow made the buds stretch a lot and be airy, not taking much light made them white and mostly tasteless (cardboard taste). Upper branches brings the sweet taste of this strain up but effects were quite low. Even thou the high is enjoyable and taste from upper buds are tolerable. Lower and mid buds gone to trash unfortunately. I'll stop for this Summer with Hydro, but will try my 3th time in winter

🗓️ Week 17: 3/23 - 3/29 📆 Week 7 of 12/12 🌄 The plant is starting to go into senescence and presenting some beautiful colors as she begins to fade. 💡 Received new lighting courtesy of Growers Choice. They sent me the ROI-E420 with the Master Controller. First impression is amazing. Looks and feels like very high quality build. The spectrum seems more blue than the 3000k lm301H Kingbrite bars I have been using. The bars are thinner and packed with a lot of diodes, so they do run a little hotter than the KB at full power. I adjusted and now running them at 90%. For now the Kingbrite bars are being used as side lighting dimmed to about 30-35% depending on Grow room temps.

Good morning, we're finally here. We've changed locations, still in southern Spain, but this time much closer to the sea and with a Mediterranean climate, like my Italian roots. Love it. We'll start with the autoflowering plants first; this time, they'll all be grown without cutting techniques. We'll always have two plants: one grown with just a little tidying and left to grow straight, and the other using techniques that don't involve cutting, and therefore slowing things down. I need weed; the grower must also consider this, so the autoflowering plants will finish as quickly as possible. In most cases, it will be a nice, firm LST, not too delicate, and I'll fim if the plant seems to touch the sky, as has happened recently, probably thanks to the Plagron fertilizers, which will be with us this time too. The chosen soil is the recently released Plagron Bio LightMix, which will allow us a more regular and reliable start without the sudden changes that liquid fertilizers can cause. We're 100% organic this time too. For the germination, we also used Seedbooster as soon as it arrived with the last and first 75% water + 25% hydrogen peroxide - *** In my opinion, it's very important to add hydrogen peroxide if you start with the seed in a small glass of water. As soon as it's opened, it would drown too; the oxygen bubbles in the hydrogen peroxide prevent suffocation. www.plagron.com Our Karen Kush really started off like a rocket, the fastest of all. We just pretended to smoke the jar of the photoperiod version and we still have the incense flavor in our mouths. Great strain, great flavor and plant. This seedling started out very well; the other had trouble releasing the seed and placenta, and germination stalled. I'm germinating another one, it's arriving very soon. https://www.zamnesia.io/en/10783-zamnesia-seeds-karen-kush-auto.html Zamnesia Description - There's no need to complain about this strain: Karen Kush Auto will satisfy even the most demanding smokers with its dense flowers, fragrant terpenes, and high THC content. Created by crossing Monster Bud Kush, White Widow, and ruderalis, Karen Kush Auto boasts first-class genetics that leave no room for complaint. Inhale its sweet, spicy, and diesel aroma and enjoy the physical buzz that envelops you. After a few minutes, the only thing you'll want is a comfortable place to relax. And best of all, you won't find this strain anywhere else, as it was created by the geneticists at Zamnesia Seeds. www.zamnesia.com

Cereal Milk (YLife X Snowman) Gave them a full day of darkness and flushed for two weeks with phd water after flushing with Advanced Nutrients Flawless Finish! UVB light did increase trichomes and it appears it sped up trichome ripening, not 100% sure on the ripening tho. WILL UPDATE AFTER DRYIN WITH DRY WEIGHT! 2/18/25 UPDATE..Cereal Milk weighted in at 39 grams so nearly 1.5oz. The scent is not so strong but it’s there and so far it’s smelling like gassy bad breath smh unless my brothers breath had my nose pallet out of balance lmfao. I’ll cure for a short time and coma back to that!

Hello! End of week 10, I'm already at the finish line. When it seems to me that nothing is happening anymore, the bending and breaking branches remind me that the plants continue to gain weight, and this is not bad. A bright berry-fuel smell appeared, I continue to monitor. Thank you for stopping by, and be healthy! 🙏 To be continued... 😶

So here we are: the seed sprouted after three days and was effectively born on Christmas Day, 25th December. 25 Dec – Day 1 Sprouted! - Temperature: 23 °C - Light cycle: 18/6 - Light intensity: 25 % → 17 W (measured with Tapo app) - PPFD: ~180 - Humidity: 80 % 27 Dec – Day 3 - Temperature: 19–22 °C - Humidity: 70–80 % (Humid Pro set to 75 %, step 2) - Growth: healthy, slightly leggy - Added small amount of soil for stem support - Watered approx. 150 ml + light misting - Water contained very small traces of BioBizz Grow, Alg-A-Mic, and CalMag - pH: 6.1 - Measured plant height (before soil addition): ~7 cm - Approx. 3 cm of stem later buried in soil - Light distance: 30 cm - Light: 25 % → 17 W 28 Dec – Day 4 - Light distance: 28 cm - Light cycle: 19/5 - Added approx. 2 L additional soil, leaving seedling ~2 cm above soil surface - Soil mix: BioBizz Light Mix + ½ tsp rock dust + ½ tsp INOQ 1001 Mycorrhiza + Perlite + Vermiculite - First single-finger leaves started growing - Light watering - pH: 6.1 - Visible plant height after soil addition: ~2 cm - Estimated total stem length: partially buried, ~7–9 cm 29 Dec – Day 5 - Single-finger leaves continuing to grow - Overall condition: healthy, compact 30 Dec – Day 6 - Installed Vivosun AeroFlux W70 heater - Previous days: temperature occasionally dropped near 18 °C, avg around 20 °C, now with the heater I hope to achieve better conditions - Heater set to 24 °C - Humidifier set to 70 %

Week 4 - plants have grew substantially and have reacted good to mainline technique.

4/20: I have 3 good clones of the shortie growing, and another FFT6 seedling. 5/1: The seedling is now in a 5 gallon pot outdoors, and 2 of the clones are in my closet getting ready to be transplanted into 5 gallon pots and moved outdoors. One of the FFT6 clones will be grown in my tiny tent. 5/6: I took the last two clones outdoors and fed them really well. I also did some training on the seedling and the clone in my tiny tent. 5/7: I did a foliar application of Axiom Harpin proteins today. 5/9-5/11: Did foliar feeding and lots of training every day. 5/12 - 5/17: Fed the outdoor girls on the 13th, then we had lots of rain all week. The seedling is a beast. Installed a new 200w 3000k waterproof LED over the outdoor plants. The indoor clone looks great. I gave her some water on the 16th. 5/18 - 5/19: The seedling and two clones outdoors are all flowering?!?! I suppose it's because I germ'd and vegged them for a month under 24/0 before taking them outdoors under 14/10 of daylight... I'm really hoping she sees the days getting longer and goes back to vegging. I need time to bush her up really well! I ordered another 200w 3000k waterproof LED to replace the two cool white 60w LED's, so that will be 550w total watts of lighting outdoors in addition to the 5'ish hours of direct sunlight they get at mid-day, and the tree-diffused sunlight they get for the rest of the day. Thinking about trying a product called Bud Bomb...has lots of hormones, cytokinins, and auxins that when applied at the beginning of flowering supposedly causes more lateral branching and less vertical stretch. As it is, I'm spending too much time training her and the other outdoor plants to stay below the eyeline of nosy neighbors, so I'm really considering giving it a shot... 5/20: I went for it and sprayed them with Bud Bomb this morning...hope it works like they claim.. 5/21 - 7/4: The clone i grew in the tiny tent got to move in under the quantum boards for her last 2 weeks and fattened up nicely. I harvested her on 6/28 and washed her buds, then jarred and weighed her on 7/3. She produced 110g of cola and 51g of lower bud...very little of it was larfy.👍 After a few great weeks flowering outdoors, i was invaded by spider mites and grasshoppers. The #6 seed-grown plant didn't make it, but i brought the #6 clone indoors and treated her for spider mites a few times, along with the 2 x #1 clones and the #7 plant. That outdoor clone now in my closet is still flowering as of 7/4, but had her last dose of nutes on 7/3. Flushing in a few days.

I still can't believe how fast these plants are. Sensational, I believe that I will be carrying out the harvest soon

(wednesday, start week 8) plants both start flowering, the water in the Dwc has only 400 ppm. this plant drinks a lot instead of feeding later on this week: changed water to 650ppm (friday) soil plant looks like its over or underwatered. i used 1/3 perlite and water once a week 1 liter. the pot weighs normal.. maybe i should keep watering everyday half a liter ? the video and pictures of these problems are added to this week, my PH meter was broke causing me to give the wrong Ph for a while.. i now use the liquid ph test kit from GHE, she starts to look better now. ill be happy to finish this i dont like all the leaves on this strain

Plants doing good clones have roots but not all guna wait 2 more weeks b4 transferring to new containers …one plant needs more food guna increase ppm

She has been growing fine a little bit on the slower side but the container is small and I burned her in the beginning. The genetics are strong and she is pulling out all the stops .The growth and side shoots are starting can't wait to see how she does by week three I've got high hopes ...Cheers canna family ..

to view this lamp or any other marshydro product go to: https://instagram.com/marshydro_aliexpress?igshid=YmMyMTA2M2Y=

Critical orange punch auto dutch passion seeds

Just been chopped toon al the lower branches off and put them away separate but will update on the total yield

Plants came back out of their 36 hours of darkness and were a little droopy, so I made the decision to put them outside for the first day of light. Unfortunately they suffered from wind burn so I brought them back to the tent. Foliar fed the plants daily at 400PPM.